(800) 853-2651
SHOP NOW

Recent content by Tom Barto

Yesterday's Tractor Forums
  1. T

    Spra Coupe 116

    I thought of that, but the grind looks like it would be considerable...and the parts are not terrible and I'd have all my labor involved in taking the existing carb off and trying that sort of fix (Im 5 mo outta a huge back surgery...so I'd rather, if I'm gonna work, fix it right... The new...
  2. T

    Spra Coupe 116

    I just found out why...Its a non stock carburator and the hook up for the governor is wrong - that bent adj bolt should be striaight and that throttle should be on the opposite side and this unit (which my guy has seen before) bumps into the alternator to prevent any additional rpm's... So...
  3. T

    Spra Coupe 116

    Yes - Ive had it about four years. The first year it had enough power to do everything needed - I was surprised...even thought I could go to 3rd gear sometimes but never did...then I replaced the generator and after that it seemed to lose the edge...I just seems I don't have enough RPMs 0 I...
  4. T

    Spra Coupe 116

    Still have a power issue on the coupe...I've replaced all inline filters - which helped...but RPMs are still low can't seem to get much more than 3000 to 3500...power problem at full tank going up hills especially...flat is not so bad, downshifting to first takes care of problem, but now I'm...
  5. T

    JD 7000 Planter Guage Wheel Repl

    nope - "Barto" is short for Bartosiewicz (in my case)
  6. T

    JD 7000 Planter Guage Wheel Repl

    Yes exactly...but if I don't spin the wheel, just wobble the wheel - I can visually see it wobble in the arm hole with the roll pin (lower hole)... I've read where they guys that do their own tire replacement get that bearing out a bit...(which is why I bought the assembly) but visually - I can...
  7. T

    JD 7000 Planter Guage Wheel Repl

    But its not loose there...I can't produce any wobble there...its loose at the gauge wheel fitting on the lower part of the arm...
  8. T

    JD 7000 Planter Guage Wheel Repl

    I replaced a gauge wheel yesterday - whole wheel assembly on my planter and it does not run true - bought from "All State Ag Parts"...not really sure its their part that is the problem - more concerned its the gauge wheel arm that accepts the bearing end that is loose - that is where the wobble...
  9. T

    1566 Air Pressure Guage

    Well...still no go.... I've verified continuity between the LHS terminal and the plug to the new filter sensor... The two nodes on the filter sensor also have continuity and are ground when I hook one of them to ground. That takes me to ground all the way up to the filter sensor gauge... So...
  10. T

    1566 Air Pressure Guage

    Jon - yours sound like exactly what I have...I know I have ignition power to the gauge which comes in on the right side of the gauge sitting in the tractor...Assuming I recall properly - it goes hot when the key is turned for start. The other side of the gauge, If I recall, I've read both...
  11. T

    1566 Air Pressure Guage

    I'm almost finished getting the tractors factory electrical system restored on my 1566 - doing all used parts - everything works good now except my air filter gauge. I've put on a new sending unit and replaced both the inner and outter filters and replaced the air sensor sending unit. I had to...
  12. T

    1566 Transmission Oil Tellite

    Bummer - none of that worked - the spring compressed easy enough - but I have never seen a light come apart like that before - never seen one work like that before.... The red bulb and silver ring were part of metal mechanism that reached back into the rear housing of the light with the J...
  13. T

    1566 Transmission Oil Tellite

    Its not workin...I put a wrench on the lens and almost cracked it trying to twist it off the chrome ring... Really not sure what to do - maybe the last owner glued it or something...
  14. T

    1566 Transmission Oil Tellite

    I'll try that - thanks - Its all apart because I just got it back together after replacing the clutch and none of the electric worked on the tractor except an aftermarket water temp sensor, so I'm getting all the stock wiring and gauges replaced and repaired...
  15. T

    1566 Transmission Oil Tellite

    Here are some pics... I cannot twist it at all - seems like it could unscrew and come off but I cannot seem to turn it... Don't want to break it if I can help it...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top