Recent content by Tom in NC

L
ford 6000

how many wide swinging drawbars with a roller have you saw on 6000"s with three point or without?
- lrb
- Post #1
- May 8, 2011
- Forum: Ford
D
[email protected]

Well no. 1 update on engine rebuild ing project. I succeeded in getting the block strpped down to the valves and cam. Popped them stuck pistons out with a wooden block and a BFH. Crank and rod bearings look almost new but will not be used again. I am likeing the idea from a couple of guys...
- Devious
- Post #1
- Aug 2, 2010
- Forum: Ford 9N, 2N & 8N
T
M Side Curtains

Here is a picture of my H but also have curtains on my M. Held on by four bolts. Can explain if you want Tom
- Tom in NC
- Post #1
- May 7, 2008
- Forum: Tractor Pulling
T
Farmall 350 Radiator

I used a honda civic radiator and made brackets to hold it also used electric water pump out of a school bus rear heater
- Tom in NC
- Post #1
- Apr 25, 2008
- Forum: Tractor Pulling
T
electric water pump gph rate

I got one off a school bus rear heater. works good
- Tom in NC
- Post #1
- Apr 25, 2008
- Forum: Tractor Pulling
T
Super M MW stroker crank and MW 4 1/4 pistons

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&item=320208231240&ssPageName=STRK:MEWA:IT&ih=011
- Tom in NC
- Post #1
- Jan 19, 2008
- Forum: Tractor Pulling
T
Super M MW stroker crank and MW 4 1/4 pistons

There is a set of sleeves like that on ebay
- Tom in NC
- Post #1
- Jan 19, 2008
- Forum: Tractor Pulling
T
broken headstuds on c152 motor

James, That happened to me and everyone said it was hopeless, machine shops included. I broke an extractor off in mine. I used a masonary bit, drilled it right out killed tyhe bit, and I retaped it, put a new stud in and tractor runs fine Tom
- Tom in NC
- Post #1
- Dec 30, 2007
- Forum: Tractor Pulling

Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy