-
TJust a heads up on the fan belts on the earlier ones. Mine's a 79 model and I just found out from an expensive lesson that they use a...
-
Ttom upton replied to the thread Shuttle Shift Tractors ????.I find by the time you back up 10 or 15 feet stick tractor back in a forward gear it dont take much longer with the clutch in till you...
-
Ttom upton replied to the thread 77 plus 310.Kinda depends on what you are doing to the 310? I am assuming you are putting together a puller? If you are buiding a serious engine...
-
Ttom upton replied to the thread 1550 Hydraulic Pump.could also just be the main relief has some crap stuck in it holding it open a wee bit?
-
Ttom upton replied to the thread Happy 8-8 day.My favorite tractor. I grew up on a 1949 88 standard diesel that Dad bought new. IMHO the best all around tractor of that time period.
-
Ttom upton replied to the thread Weedy oats.I bought an old JD 800 swather years ago when oats were down and full of green. After it was all dry ( layed there for 3 or 4 days) went...
-
TYa, that's the Dickens of it. You start working on these things in your teens and have them around all your life, but these old ones get...
-
Ttom upton replied to the thread 1550 Cockshutt pto.Yes you are correct. I took a look just now and clutch discs can be done without removing shaft. I should have known this as just did my...
-
Ttom upton replied to the thread 1550 Cockshutt pto.No worries will get you something in the morning.
-
Ttom upton replied to the thread 1550 Cockshutt pto.I am pretty sure you need to pull the shaft and all. rrlund was right the first time he posted. Its not hard to pull the shaft out once...
-
TThat sounds like you had JD's Equal Angle Hitch. Set correctly it makes it so that the u-joints are at the same angle during turns...
-
Ttom upton replied to the thread Swivel Hitch.I had a 1209 JD haybine once that had the swivel ball on the haybine and a fixed pin that bolted up to the drawbar of the tractor. If...
-
Ttom upton replied to the thread Allis CA questions.I guess us Canadian farmers have some of our own terminology for things. Up here if you said to cultivate corn v/s scuffle corn we would...
-
Ttom upton replied to the thread Allis CA questions.My Dad bought a CA new pretty much just to scuffle corn. I see the one you are looking at is set up for scuffler as well. I still have...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy