(800) 853-2651
SHOP NOW

Recent content by Tommy Baynard

Yesterday's Tractor Forums
  1. T

    adjusting valves

    what do valves set on cold and what is sequence to adjust thanks in advance for the info Wd45pulling tractor
  2. T

    lining gas tank on wd

    whats the best procedure and whats the best stuff and where to get.getting very small rust particles
  3. P

    806 hydraulics

    Having trouble with lift wanting to raise just recently changed fluid and filter.Have discovered if i take the plug out of the side of the pump air comes out then it will start working, but if i let it set for few minutes i have to take the plug out again. My dipstick reads more than full but my...
  4. R

    TO 30 Key medalion

    Does anyone know where I can locate a TO 30 ignition key medalion? It is the one that shows what position the key is in.
  5. R

    atv and snow mobile forums?

    I need to get info on my Polaris 4-wheel drive Sportsman 400 ATV and Arctic Cat 5000 snowmobile. Is there a forum for these someplace. I checked this site, and came up empty. Thanks...Ron
  6. 4

    pictures

    Can anybody tell me how to post a pic on this site, I have a high track D from the Waterloo two cylinder club show to show off
  7. T

    tsx68carb

    I am hunting a marvel tsx carb. The carb fits a gta or a gtb moline. Does anybody have one for sale or maybe point me in the right direction. Thanks in advance for the help!! Tommy in NC[TSX 68 carb]
  8. T

    mlpankey

    Thanks Mitch you have come through again!!Tommy in NC
  9. T

    mlpankey

    Hello Mitch Hope all is going well. I am having trouble finding a carb if you could point me in the right direction I would appreciate it.A carb number might help. Thanks again for all the help.Tommy in NC
  10. T

    more rpms

    Thanks Mitch I must have missed your responce about the 464 carb.What kind of carb do I need and do you think I should leave my governor alone.I knew you would reply and I always appreciate your help.Have you pulled your Allis yet and how did it do?Thanks Tommy in NC
  11. T

    Bigger ventura

    I need a bigger ventura for a tsx 464. Where can I find one or does anybody make them.Thanks!
  12. T

    more rpms

    I need a few more rpms on my wd 45. I have the good spring already. I want to work on the weights but need some good advice on how and what to do. exactly how much and where to grind weights. Everybody says you have to be very careful. any advice are pictures would be greatfully appreciated also...
  13. T

    tires

    To Joe M (GA) Do you have a copy of wheel and tire sizes for WD.Need to know if WD came with 38s.Thanks in advance. Tommy in NC.
  14. T

    im so excited

    Hello Mitch Thanks again for all the advice and was wondering where you pull. I would like to see you pull when you get the big motor going. If its not to far it would make a good road trip.If you could give me some dates and locations I might get down your way this summer.Tommy from N.C. Thanks!!!
  15. T

    Trans clutch in a WD

    Thanks Mitch I knew you would answer.You have always been very helpful!Now can you tell me where I might find a hub?Thanks again Tommy in N.C.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top