Recent content by Tophers_Farm

  1. T

    Farmall Super A starter serviceable?

    Update: starter turns fine on the work bench, but does nothing on the tractor (still shorting it out to bypass the switch just in case). Tested the amperage on 3 batteries (all good) even tried using the MF 85 battery which is two honking 6v in series (the farmall is converted to 12v). So what...
  2. T

    Farmall Super A starter serviceable?

    I found a great video to help! https://www.youtube.com/watch?v=iQ00AG9d42c I thought the cover and case were all one piece because someone had put scotch tape over the clamp. Making progress...
  3. T

    Farmall Super A starter serviceable?

    Update: I took it apart to inspect the armature and commuter, although a cleaning wouldn't hurt it doesn't look that bad. I wanted to try to connect it to the battery on the work bench (maybe the battery amperage is not enough to turn it against the motor), but when I went to insert the...
  4. T

    Farmall Super A starter serviceable?

    Can I just hook up the battery directly to the contact on my workbench? Would be a lot easier to troubleshoot if I didn't have to work on it at the tractor...
  5. T

    Farmall Super A starter serviceable?

    I can rule out the switch, I took the switch off and shorted out the contact directly. Motor turns I had it running easily via compression. I'll start dismantling the starter and see what I can find. I'll need some help there as all of the vocabulary i've read so far (armature, brushes, etc)...
  6. T

    Farmall Super A starter serviceable?

    Farmall Super A starter was hit or miss last year. Upon pushing the button often nothing would happen then randomly it would fire right up. I put oil in the little filler hole, but there wasn't much of a difference it was all or nothing, it seems to be an electrical contact issue. This year...
  7. T

    Prime power steering line on MF 85?

    So the strainer does not appear to be sold separately from the pump which is over 1000$ Looks like this will need to be a custom job, I think I can remove the strainer plate and weld something similar to it (lucky to have genius welding shop next door) any advice would be appreciated. If I'm...
  8. T

    Prime power steering line on MF 85?

    Update: I removed the pump and the strainer is gone! I threw on some mechanic gloves and fished around the trans and there's nothing there. The strainer already had a hole in it so I'm assuming it disintegrated and went threw the pump. I'll remove the filter and see if I can flush the line...
  9. T

    Prime power steering line on MF 85?

    I'll check the pump and filter again... It's hard to think the pump would stop working with such a simple design.
  10. T

    Prime power steering line on MF 85?

    I flushed the hydraulics on my MF 85 (it was contaminated) and drained the power steering pump lines and cylinders. The power steering pump draws hydraulic fluid from the trans reservoir, but I think there is still air in the power steering lines/cyclinder. Anyone know how I would go about...
  11. T

    Work cylinder rod pin, is there play? MF-85

    Is the pin for the work cylinder rod to the ram arm supposed to have some play with the hole in the rod? I have not been able to find this exact part so I will to have to make one, there are 2 pins in the parts manual, but it is difficult to tell which one is which. It looks as though I am...
  12. T

    Farmall vegetable oil instead of trans oil?

    I have several Transmission leaks on my farmall super A. I'm cultivating a few acres of root vegetables and I don't want oil in the field so I just let it run dry (well actually there's still oil, but well below the seals, so would imagine it's not getting the gear coverage it should have)...
  13. T

    MF 85 Hydraulic cover/ram cylinder removal...need help!

    At this point it's about access. The trans area has very good access via the PS pump and opposite side access plate and I can clean that out with out splitting it. The problem is access to the hydraulics area and on most models in that era it is relatively easy to remove the hydraulic cover...
  14. T

    MF 85 Hydraulic cover/ram cylinder removal...need help!

    Here's some pics of the Auxiliary plate: [/img]
  15. T

    MF 85 Hydraulic cover/ram cylinder removal...need help!

    I have a nice MF 85 1959 Diesel that needs the hydraulics/trans/power steering thoroughly cleaned. I've done some research and spoken with a mechanic with experience in old massey's, but I could still use some pointers and any advice will help. The short of it (the long version will...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top