(800) 853-2651
SHOP NOW

Recent content by Trapper D

Yesterday's Tractor Forums
  1. T

    Pole Boom Question

    I did not take pictures since I was driving but I picked a 4.6 Ford motor with tranny and transfer case attached. Just barely had enough lift to get it out of the bed of the truck though. When I move it out of the garage maybe I will take a few pics. Maybe the best attachment I got.
  2. T

    OT - Bats in the Attic

    You could always put screens in your vents if you are worried about the gaps. As far as bats go they would not be crawling in the insulation and they would be sleeping during the day. My guess is that it is mice or chipmunks. Squirrels would need a little larger hole but they can make it in...
  3. T

    Charging issues

    I will try my luck with a new regulator then. I figured it would not be a good idea to run it at full charge with it jumped but it was worth asking. Thanks for the advice.
  4. T

    Charging issues

    I found the regulator. Thanks. I know Dell did not seem to believe that I have a generator but I posted a few pics to prove it. I will ask you the same question I asked him. Would you be able to permanently jump the 2 terminals on the generator or would that burn something up? I know you said...
  5. T

    Charging issues

    Found it.
  6. T

    Charging issues

    This is the generator.
  7. T

    Charging issues

    Sorry I have not responded but had some stuff that pulled me away. I will check under my oil pressure gauge for a regulator. I know on the left side of the tractor there is only a starter, solenoid and generator. I did not know if the regulator was internal or what. Would there be a problem...
  8. T

    Charging issues

    Well I have been having some trouble with my 6 Volt 8N charging. I have to take a screw driver and jump the two terminals on my generator to get it to charge. Once it starts charging it does ok but eventually it stops again and even goes into the neg. on my gauge. Is it the generator or the...
  9. T

    8N Crankshaft Pulley Replacement

    If everything else fails just weld a bolt off the end and use it to turn it off. At least then you can get a socket on it. A small pipe wrench or channel locks may work also. Good luck.
  10. T

    Learned something new today

    Soak some rags or cotton balls with mint oil or mint leaves. Place them around none mouse spots under hoods or pipes and the mice will stay clear. Mint is a natural deterrent for mice. Planting mint around you house will keep them from coming in also. I hope this helps someone.
  11. T

    Genarator question

    It is not charging. I will try to jump those two terminals tomorrow.
  12. T

    Genarator question

    Si if I understand correctly I would leave all wiring as is but connect the to terminals on the generator.
  13. T

    Genarator question

    Sorry for the misspell. It should say Generator.
  14. T

    Genarator question

    I have a mutt 8N tractor that I have a question about It has a stationary industrial engine with magneto and 6 volt system. My question is how do I check my generator? I have a volt meter but am not sure how or where to place my positive and negative. I also believe I will need a jumper wire but...
  15. T

    OT: Diggers

    I trap a lot and I agree that you need to identify the critter but one fail safe is quick creet. Even with groundhogs that are a pain and notorious for digging back into borrows. You can stuff rocks and mesh forever and they find a way back. I have found that most critters will abandon the area...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top