(800) 853-2651
SHOP NOW

Recent content by traviss224

Yesterday's Tractor Forums
  1. T

    TO-30

    Ok I got the ignition parts in and installed. In the meantime I have had the old carb soaking. I put it all back together awhile ago and it fired up and idles pretty decent. When I get back from town I will adjust the timing a little more. It still has a slight roughness to it. I hope it will...
  2. T

    TO-30

    Eric what do you mean by police inlet?
  3. T

    TO-30

    I do still have it.
  4. T

    TO-30

    I ended up buying a new one from jensales. I have had the original apart several times, soaked it and ran cleaning tips through it but it won't even start the tractor. The Chinese one is starting it. I'm hoping the one I ordered will be usa?????
  5. T

    TO-30

    I do feel as if its the carb... I am on the phone now trying to order one. Any recommendations?
  6. T

    TO-30

    The spark is very light. It doesn't seem stronge.
  7. T

    TO-30

    I bought it. It has been sitting in a garage for 10 years. I bought a new carb, empty the fuel tank and cleaned it out, new petcock, fuel line, filter, spark plugs. It ran ok before I removed the distributor to get the starter in and painted the tractor. I set it to TDC on what I believe was...
  8. T

    TO-30

    I tested my coil tonight. Any way to see if it's 6 or 12v? Here is what it tested. Center to neg or POS 11.63 + To - was 01.3 Good or bad?
  9. T

    TO-30

    I messed with it for a bit today. It will run ok for about 10 seconds then die as of its been cut off. I ordered new cap, button, coil etc yesterday from Steiners tractor. It should be here next week and I will report back
  10. T

    TO-30

    I went ahead and order new points and stuff. I will update later. Recommendations on spark plugs?
  11. T

    TO-30

    Thank you. I will pull it back apart tomorrow. How do I check the points gap? When it's on the flat side or when it goes to the high part? And do I check the gap against the shaft or what?
  12. T

    TO-30

    I have a Ferguson to-30. I am trying to set the timing on it. When the timing marks are lined up at TDC, I install the distributor with #1 at the 10 o'clock position. The metal part of the button is facing #1. It won't run here. I rotate it 180 degrees. It runs, but rough. Any idea?
  13. T

    1978-9 Cat D3

    Ok thanks, on the side I have about an 1.5" plug and about a 1/2" plug that is recessed. I'm assuming it's the smaller one?
  14. T

    1978-9 Cat D3

    Ok thanks, on the side I have about an 1.5" plug and about a 1/2" plug that is recessed. I'm assuming it's the smaller one?
  15. T

    1978-9 Cat D3

    Is this where you check the pressure? It's two lines?[/img:eb4103587f]
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top