-
T
IH 384 fourth gear split
Barnyard, no the videos didnt show exactly what i was asking, I did watch a few and basically piece together what i was asking.I did comment on one of Daves videos and he did answer quickly and said it was doable. Jim, the hydraulic assembly was tricky without some type of hoist but I did...- TrentB
- Post #7
- Forum: Farmall, International & McCormick
-
T
IH 384 fourth gear split
Thanks Jim I have already watch several of his videos I had considered asking him directly, but havent yet. Is does look like from his vids that if I take the snap ring off of the pto shaft that I would be able to split it between trans and clutch housing.Red I have already purchased those pdf...- TrentB
- Post #4
- Forum: Farmall, International & McCormick
-
T
IH 384 fourth gear split
I have an international 384 with worn quill gear bearings. Do I have to split the tractor at the engine or can I just split it at the clutch housing/transmission.- TrentB
- Thread
- Replies: 9
- Forum: Farmall, International & McCormick
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy