(800) 853-2651
SHOP NOW

Recent content by TunaIL

Yesterday's Tractor Forums
  1. T

    2600 lack of steering

    Was able to adjust all of the slop out of the steering! Its like driving a new tractor. Thanks again Ultradog MN!
  2. T

    2600 lack of steering

    Thanks Underdog MN, I'll get it checked out this weekend. I've been oh here since 2004 it says, just normally reading the posts. Better for me to be thought a fool that open my mouth and remove all doubt.
  3. T

    2600 Ignition switch

    Thanks, got it running today
  4. T

    2600 Ignition switch

    Just picked up a new to me 1977 2600 diesel, with a bad ignition switch. The current one is a automotive style switch. Bought a correct 2600 switch. I figured out my hot going to #1 and starter relay going to #4 on the switch. Then I have a wire (brown) coming off the alternator that I have no...
    • TunaIL
    • Thread
    • Replies: 2
    • Forum: Ford
  5. T

    860 no lift on 3pt.

    Update, the hydraulic piston pump was bad. I rebuilt the pump, and bled it. Now have movement on the 3 pt. Will replace the o rings on the lift cover and cylinder. thanks JMOR
  6. T

    860 no lift on 3pt.

    I pulled the hex plug out of the pump and primed it, still no movement on guage at test port.
  7. T

    860 no lift on 3pt.

    It's not even showing 40 psi, no movement on the gauge at all.
  8. T

    860 no lift on 3pt.

    Bought this tractor knowing the the 3pt was not working. I have no psi at the hydraulic test port. I swaped the piston pump with a known good pump off my 640, still no psi. Checked in side the transmission with the clutch in, saw no stream that would indicate a rusted hydraulic line, no...
    • TunaIL
    • Thread
    • Replies: 6
    • Forum: Ford
  9. T

    NAA weak hydraulic pump?

    The lift is smooth, but very slow. If it sits more than a day I have to bleed the air from the pump at the pipe plug on front of pump. When bleeding the pump it takes 20-30 sec to go from bubbles to oil to get the air out.
  10. T

    Anyone interested? CASE Loader Tractor

    I'm very interested, will be thru that neck of the woods next week, any ideal what they are asking for it?
  11. T

    310 backhoe reservoir

    Hydraulic reservoir is shot, my question is has anyone mounted a replacement resrvoir on the side or some where else, Also I"m guessing about 7 gals does that sound right? thanks Charlie
  12. T

    Reservoir310B/H

    My reservoir sprang a leak and I need to pull it. Looking at Case CE parts it looks like 2, 24" long bolts go thru it on the bottom does this sound right? Anyone pulled the reservoir off that has any tips? Thanks Charlie
  13. T

    U joint at steering gear box

    Well I hope a new yoke can be had from Case, after too many hammer blows to my hands, I took the cutting torch to the yoke. After spliting it, it looks to be a double clutch from the pics that I have seen here on the board. Thanks again Charlie
  14. T

    U joint at steering gear box

    57 round nose 310 with B/H, I have the roll pin out at the front u joint at the gear box, How do I get it to slide off? Whats the trick, don't want to use heat, too much grease and dirt. Its the last thing left before I split the tractor. Case shop manual states move reward. The loader/ back...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top