(800) 853-2651
SHOP NOW

Recent content by TWRaska

Yesterday's Tractor Forums
  1. T

    Cotton picker Spikes

    5/8? spindles????? I don?t know what machine took those. Steel bar red and green machines were 9/16 and newer aluminum bar machines were 1/2?. I have probably 1500 or so 9/16? spindles out of some red two row machines but they have some rust on them. Would those work? Tim 9795717097
  2. T

    Cotton picker Spikes

    Do you only want the 9/16? or can you use 1/2? as well? Tim 979-571-9097
  3. T

    Massey ferguson 1080 engine

    The tractor is located in Wallis Texas, about 50 miles west of Houston. The engine runs great, only thing wrong with tractor is belly pump for 3 point is not working and the seat leaves a little to be desired. Tim Raska 979 571 7097
  4. T

    Massey ferguson 1080 engine

    Is a 1085 the same engine? If so, my son has a complete tractor with a good running engine he?d sell right.
  5. T

    Correct 'white' paint for Farmall 230

    OK, learned something new today, I didn't know the sides were a decal. We assumed the emblems were never off, but it was definitely paint that I blasted off. Was the original color a white or cream like the 935?
  6. T

    Correct 'white' paint for Farmall 230

    Does anyone have the CORRECT paint code for the hood and grill on a 230? Dealer gave us IH935 (991115N new #). We tried to match it with DuPont but the color they crossed to was almost pure white. The paint under the emblems (we think the original paint) was a cream color that looked similar...
  7. T

    IH Rear Blade

    Would you happen to have a link to the book/page on the Case site? I can't find a number 1 blade. I get 50-54, 10 & 11 but no number 1.
  8. T

    IH Rear Blade

    Should have added in the original post, this blade has the small forks, not the big ones. From what little paint there was, one part, the pivot was red but the blade (moldboard) and 2 point almost appear to have been blue.
  9. T

    IH Rear Blade

    Definitely IH, as its got IH part numbers in the castings.
  10. T

    IH Rear Blade

    What model is this rear blade and what color should it be?
  11. T

    F-450 dually fuel mpg?

    Son's started out getting 12 empty and 10 with the gooseneck. Now after 30K it's down to 10 empty and around 8-9 pulling with the lowest at 6! Mileage is terrible and Ford can't seem to figure out why it went down, said they all do that.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top