(800) 853-2651
SHOP NOW

Recent content by Txfarmer1

Yesterday's Tractor Forums
  1. T

    Case IH 685 with (2250 loader)

    This message is a reply to an archived post by Txfarmer1 on January 30, 2017 at 01:32:02. The original subject was "Case IH 685 with 2250 loader". Guys, my apology. I can't believe I haven't replied to this old post. I change the hydraulic filter below the seat and everything worked fine...
  2. T

    Old Raked Hay on the field!! Help!!!

    Very dry here Paul, we had a bad drought about five years ago and we are just recovering. Trees are still dying from the drought, but its been very very dry the past few months. It rained that one day I was baling and on and off the next day.
  3. T

    Old Raked Hay on the field!! Help!!!

    What if I just bale that old cut hay and then wait a couple of days to cut/rake/bale that area ? Its been very very hot here in East Texas, we have hit temps of 106 this week.
  4. T

    Old Raked Hay on the field!! Help!!!

    Ok, well I may not be able to even do that side of the field then.
  5. T

    Old Raked Hay on the field!! Help!!!

    Will the old hay spoil my new hay when I bale it? It hasn't rained since, and the daily temp has been at 100 degrees the past three weeks.
  6. T

    Vicon CM216 Disk Cutter

    Yes, it is coming from under only one disk/blade holder, the rest are clear and clean. I will be cutting 30 acres next week and was just wondering.
  7. T

    Hay prices up

    Here in East Texas, our 4x5 rolls average about $50-$60 a roll. I sell for $60 to my normal customers, but only because I deliver and its all fertilized with no weeds. Other hay farmers around the area are charging from $75-$100 a roll to the buyers that are coming in from the surrounding cities.
  8. T

    Vicon CM216 Disk Cutter

    When adding oil into my cutter bar I noticed afterwards once I raised the bar up in route to the hay field, that I had a small leak coming from under one of the cutter holders. But it only seems to leak when the bar is raised. Do you all think its a good idea to finish this hay season and just...
  9. T

    Old Raked Hay on the field!! Help!!!

    I cut and raked my hay field about a month ago and started baling. After about 20 bales, it started pouring rain for the next two days. Now that my second cutting has grow up, I'm needing help on how to deal with the clumps of windrows on the ground. Do I just rake them up before cutting again...
  10. T

    Vermeer 605H Baler belts - Baler Starter Flap

    Where is the best and most reasonable site to buy Baler belts & Baler Starter Flaps?
  11. T

    Vermeer 605H Chain.

    Here is pic.
  12. T

    Vermeer 605H Chain.

    Hi Larry, do you make this chain?
  13. T

    Vermeer 605H Chain.

    Is there a tool that I can purchase to help remove and install the new link section?
  14. T

    Vermeer 605H Chain.

    Morning Paul, What's a mender? And where can I purchase one?
  15. T

    Vermeer 605H Chain.

    I don't really have the funds to purchase a new chain, but was wondering if I have one damaged Link on the chain can I just patch it up with one link? Or is there a cheap fix? I really just need it to last this hay season. Thank you guys in advance.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top