Recent content by Uppercut11

  1. U

    Ford Jubilee 3 point doesn't move

    Thanks. I fired it up today and brought it to low idle and was going to put some compressed air into the dipstick hole to prime the pump and it just started working. Guessing that it got prime on its own. Either way I will take the good luck.
  2. U

    Ford Jubilee 3 point doesn't move

    Thanks. What is the "hy-trol" knob?
  3. U

    Ford Jubilee 3 point doesn't move

    I was given a ford jubilee that hadn't run in over 16 years. Through lots of work over the last couple of months I got it running. The problem now is that whether the selector for the 3 point is in manual or draft mode, the 3 point doesn't move. It has the original vane pump (see picture)...
  4. U

    Ford Jubilee with MF 200? Loader Belt Replacement

    Any down side to taking the bolts out of the crank drive hub and trying to slide the whole thing out far enough to get the belt behind it? Thanks for the clarification on the parts. I understand what you are pointing out now. Focus right now is seeing if I can get it running before I replace...
  5. U

    Ford Jubilee with MF 200? Loader Belt Replacement

    The shaft is splined going into that casing, but I can slide the pump and shaft out maybe 1/4" to 1/2" and the spined shaft slides easily in the casing so I don't think it is rusted up. I am just not sure why I can't slide it further. Maybe there is a pin or something in the end of the shaft...
  6. U

    Ford Jubilee with MF 200? Loader Belt Replacement

    It didn't have a battery when I got it so I decided I might as well convert it to 12V since I had to buy a battery anyway. I have also heard and read that they start really rough with a 6V. It is hard to see much inside the tank, but it looks like there is some shilac build up from the gas that...
  7. U

    Ford Jubilee with MF 200? Loader Belt Replacement

    The shaft is splined going into that casing, but I can slide the pump and shaft out maybe 1/4" to 1/2" and the spined shaft slides easily in the casing so I don't think it is rusted up. I am just not sure why I can't slide it further. Maybe there is a pin or something in the end of the shaft...
  8. U

    Ford Jubilee with MF 200? Loader Belt Replacement

    The shaft is splined going into that casing, but I can slide the pump and shaft out maybe 1/4" to 1/2" and the spined shaft slides easily in the casing so I don't think it is rusted up. I am just not sure why I can't slide it further. Maybe there is a pin or something in the end of the shaft...
  9. U

    Ford Jubilee with MF 200? Loader Belt Replacement

    I was just given a ford jubilee with what I believe is a massey ferguson 200 series loader (the model plate is gone). The tractor hasn't run in ~16 years. I have changed most of the fluids and will do the rest before I try to start it. I took off the oil pan and cleaned it. I also rebuilt the...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top