Recent content by usedcarguy

  1. usedcarguy

    Starter just spins....no engagement 1950 8n Front mount

    Annnnddddd......Since I will split it....should I replace anything in there while I am at it?
  2. usedcarguy

    Starter just spins....no engagement 1950 8n Front mount

    That is not a pretty sight......SO.....I'll have to block the tractor up. Never done this before......mechanically inclined. How many hours of work and how many beers is this job going to be?
  3. usedcarguy

    Starter just spins....no engagement 1950 8n Front mount

    That is my line of thinking.....what in tarnation would cause a retaining pin to come loose? Is it a symptom of something else?
  4. usedcarguy

    Starter just spins....no engagement 1950 8n Front mount

    Pulled the starter motor.....the pin at the end of the shaft is missing. Is this something I will have to go fishing for or is it ok to leave the loose pieces in the lower housing?
  5. usedcarguy

    No power....runs but wont throttle up

    Poured another 3 gallons in....same result. It just wants to sputter and not really take off. Kind of like it being starved for fuel but it is not.....cant be because the carb on the tractor works just fine on another tractor.
  6. usedcarguy

    No power....runs but wont throttle up

    Yep. I think the fuel is ok.....I swapped the carb from my verry well running 1950 front mount 8n. I had spark on all cylinders...how do I easily test for "good" spark? I did do an electronic ignition mod to it....kind of wonder if that may be the issue. Not making any sense. Also...
  7. usedcarguy

    No power....runs but wont throttle up

    Fuel 1:32 for 16 OZ.......about 1.5-2 Gallons of gas in her. Compression: 1 110 2 110 3 105 4 105 This is 4 Compression strokes.....I can get another 5 pounds if I go to 6 strokes
  8. usedcarguy

    No power....runs but wont throttle up

    Gas is new. 93 octane
  9. usedcarguy

    No power....runs but wont throttle up

    When I bought it.....I drove it for about 2 minutes and parked it in my garage. It ran horribly compared to my other N. It has sat for years. Going to push it back into the garage and do a gas flow test. Last year I converted my front mount 1950 8N to electronic ignition and 12 V...
  10. usedcarguy

    No power....runs but wont throttle up

    1950 8N Side mount. Has a new 12V conversion with electronic ignition. 12V battery. The old mule will run but it does NOT like to be throttled up and would rather idle. It wants to be choked a bit to make any attempt at power. I have swapped out the carb from another 8N (1950 front...
  11. usedcarguy

    8N 1950 Side mount

    Ok. did not take it off the gauge but did disconnect it where it has it's connection 12" away. NO oil comes out. What is the next best spot to look at or have we advanced to dropping the oil pan?
  12. usedcarguy

    8N 1950 Side mount

    It just shows zero
  13. usedcarguy

    8N 1950 Side mount

    Finally after spending months in St Louis MO, I am back in Michigan. Got the almost 10 yr old project rolled out of the garage and fired it up....but....it does not like to keep running. Just in case it could be a carb issue, I swapped the carb from my 1950 front mount and it still runs...
  14. usedcarguy

    Helicoil VS Insert for head bolt threads

    Ended up with a TimeSert 7/16 insert kit. Worked like a charm! Before & after pics. This post was edited by usedcarguy on 05/07/2023 at 10:13 am.
  15. usedcarguy

    8N 1950 Front mount

    Lots of oil getting by the front seal. Is it best to replace with a new rope seal or go with the one piece? Is there more work with either of them? Have the head off, doing 12 V Conversion at the moment. May as well fix the problem as I have the tractor semi disassembled.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top