Recent content by Volksman79

  1. V

    RE Volksman79 Backward throttle

    Not the best picture but you can see what I mean.
  2. V

    ITS ALIVE!!!!!

    So what color are you going to go with the red, blue or yellow?
  3. V

    RE Volksman79 Backward throttle

    That is how I finally figured out what was going on. When I put the throttle lever on the steering column it was pushing the throttle rod to the idle position. How I was running the tractor when I bought it. When you pushed it forward to what would be Idle it was opening the carb. I could not...
  4. V

    Backwards throttle

    Since the day I bought my TO30 the throttle has never been right. After I did a full rebuild of the entire engine system of the tractor I could not get the throttle right following the service manual. I finally figured it out. This is my first Ferguson mind you. The throttle was backwards...
  5. V

    Throttle Adjusting

    That is what I thought but when I bought it the guy showed me the other way. It has never been right. No better time than now to fix it.
  6. V

    Throttle Adjusting

    Thanks guys. I have had problems with the throttle since I bought it last year. This make a lot of sense. I will adjust it tomorrow. It bothered me that every other tractor I have run was to pull it towards you to raise it. This should help a lot. Thanks again guys. Now the book should be helpful.
  7. V

    Throttle Adjusting

    I went to adjust the throttle today and correct me if I am wrong but the service manual seems to have the directions backwards. Anyone else have this problem? It says to move it forward 65deg to put it in idle. I thought idle was when it was touching the steering wheel. Can anyone clarify...
  8. V

    thanks fellas.....

    Best of luck to you. I just finished my first rebuild and it runs. It took a lot of patience and a lot of help from this site but I got it done. You can too.
  9. V

    ITS ALIVE!!!!!

    Thank you so much to everyone for the input and tips. After a full engine rebuild carb rebuild and all new wires rotor cap points condenser and resistor. Good old Fergie fired up. The whole thing after the rebuild came down to the rotor. When the engine was at TDC on 1 the rotor was between...
  10. V

    weak spark

    I am going to take it apart and check tomorrow. I need to check the valve settings anyways. It will be a good time to see how things are lined up in there.
  11. V

    weak spark

    I spoke to a friend of mine who is a retired Ferguson Mechanic and we walked through everything. It looks like my resistor is shot. The connectors are lose inside the resistor and the spark is weak. I will change it out tomorrow and see what happens. I also need to double check the valve setting...
  12. V

    weak spark

    That is how I have it. I just can not get it to go. The plugs are getting wet when I try to turn it over. Does this mean it is to rich? The engine turns but will not fire. I have spark and gas but no luck. The exhaust is puffing so that is not blocked. I need to measure the voltage across the...
  13. V

    weak spark

    I have gas to the carb. New screen and new fuel filter. I did get spark back. and the plugs get wet as I am trying turn it over but nothing fires
  14. V

    weak spark

    I was able to get spark again. The wire was a little loose in the cap so I adjusted the end a little and it came back. I will give it a shot with the gas and see if that does the trick. I did try starter fluid in one but that did not do it. I have the carb set at 1 1/4 turn on the main jet and...
  15. V

    weak spark

    1 should be the top left correct? Then 3,4,2. I just can't figure out what is going on. What else should I be looking for?
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top