(800) 853-2651
SHOP NOW

Recent content by wbecker319

Yesterday's Tractor Forums
  1. W

    d 15 engine

    There are more issues to solve. I put a D14 engine in my B, it was the 149 ci. engine, the D15 II is the 160 ci. For the D14 end in the B, yes I had to use the B clutch. Also had to use the B radiator and fan. The water temp gauge is electric and needs to be mounted somewhere, the muffler hole...
  2. W

    G rear hydraulic lift

    Looks like it"s the same cylinder as on a B or C
  3. W

    D10 rear wheel weights

    Thanks, but I bought a pair today.
  4. W

    D10 rear wheel weights

    I am looking for rear wheel weights for my D10 with spin out wheels. Casting # is AM3733-2. Thanks, Bill B [email protected]
  5. W

    674 Picture

    See previous post. The 674 picture was missing. They are located in central WI. Thanks
  6. W

    Value of a W6 674

    My mother in law has a W6 and a 674 she needs to sell, I don"t have any idea what to tell her to ask for them. They ran when parked in the shed about 14 years ago. I started the W6 once 5 years ago. The W6 rear tires look good, don"t remember the 674 tire condition. Thanks, BB
  7. W

    ring gear on a c

    If you flip it you won't have the chamfer on the end of the teeth for the starter gear to slide into. You could remove it and rotate it, a 4 cylinder normaly stops in 2 areas on the flywheel, so if you retate it 90 deg it will be stopping in an area where there is very little wear.
  8. W

    piston and sleeves

    I have been told you can take off .150" without a problem. I do not have first hand experience. Bill B
  9. W

    WC Stubborn when hot

    Hard to start when hot is VERY often a bad coil in the mag. Bill B
  10. W

    Magneto Questions

    A coil can test ok but cause problems when hot. Bill B
  11. W

    Starter

    What is an AC model L ?? Bill B
  12. W

    re: paint color for WC

    What Ted said. Bill B
  13. W

    allis b magneto broke

    I have 2 FMJ4B3 mags on B's, the ground is on the right side. Bill B
  14. W

    restoring '39 Allis B

    I would find a shaft without the U joint, should not be hard to find.
  15. W

    Allis-Chalmers B or similiar lowered

    I have a "Low B with a 6' Mower under it. Bill B
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top