(800) 853-2651
SHOP NOW

Recent content by wforpm

Yesterday's Tractor Forums
  1. W

    tires ,tires ,tires

    I'm looking to have a second set of tires for the Spring / summer..... remember that....... would like to have a set of turf tires for the little woman's lawn . As the R1's make a mess for mowing , and I don't want to start doing that ! LOL . What size can I use comparable to my 12.4-28's rear...
  2. W

    Electrical update

    Yes , I did get the parts from this site. Electronic ignition , and coil. I also got the 12volt conversion ,alternator and such a couple of years ago , and it never worked as good as it does now. Next to build a cab and get ready for winter. Have had the wood stove running 2 nights now !
  3. W

    Electrical update

    Hello All , just an update. I posted a month or so ago about my TO-30 stalling after running for 1 or 2 minutes. I was going to install an electronic ignition and the coils recommended from this site. Happy to announce it is working like a charm . Starts , in half a turn , like it always did ...
  4. W

    12 volt conversion

    I have a 51" TO-30 that has the 12 volt conv. kit , purchased from this site , Neg. ground. with ballast resistor , coil with condenser and dist. w/ points. She keeps stalling after a minute or 2 when first started. Then sometimes will run fine. Getting gas , but stalling / shuts off like...
  5. W

    post hole digger

    Works on my TO-30
  6. W

    Preventitve Maintenance

    OK , mixed reviews . It's in a heated garage. Never used in the rain , or while snowing , pretty much babied . Thanks Again Bob
  7. W

    TO-30 front loader lifting problem

    Hay Phil , what model Wagner do you have ? One bucket tilt piston or two ?
  8. W

    Blade for snow removal

    Has anyone used a rear blade for snow removal ? If so what size ( 5' , 6' or 7' )is best and are tire chains needed ? Also , what brand ? Are TSC blades any good ?
  9. W

    Speaking of mufflers

    Got mine from this site. It is a horizontal , under the tractor , and is quiet . After having a cut off pipe before that.
  10. W

    here we go again.....

    I think Sam is right , you might need a few Moulsons before buy-n this one. If no water in oil , engine is loose , it rolls . I'm thinking 2 fitty .......... probably will cost you that in rust-o-liummmm . LOL
  11. W

    Tractor cab

    :idea: This has given me some incentive to build a cab. I think some welding , cutting and fab'n are in order. Thanks All !!!
  12. W

    Timing w/ timing light

    Does any one have the procedure for checking timing using a timing light .
  13. W

    Oil slinger problem

    Took off the camshaft cover today to check the govenor spring. Found the oil slinger was looking strange. Not sure what someone has done , but I'm sure this is not what it should look like. Is this something that is needed ? Where would I get one ? Does anyone have one out there , for a TO-30 .
  14. W

    What to do ?

    I have taken the carb off , its new , and checked all filters and float level. It was clean , but the main jet has build up on it. Almost like rusting. Sometimes it will run perfect then it will start to sputter and the gov"nr trys coming in. This with NO load on it. I have a hill to test on ...
  15. W

    What to do ?

    :? TO-30 with over size pistons. Trying to set carb. But getting pulsing while running / testng . At idle it runs smooth as silk , 1/2 throttle and it starts to pulsate and the guv'nr keeps trying to come in . Do I need to adjust the linkage more ? Main jet is out 2-1/2 turn , otherwize it...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top