(800) 853-2651
SHOP NOW

Recent content by Wild child

Yesterday's Tractor Forums
  1. W

    Need 2 graden tractors hauled

    Looking for someone to haul a Hiller and a Bantam garden tractor from Pennsylvania to Minnesota. These tractor are pretty small and do not take up a lot room. Thanks Rod
  2. W

    Rear rims

    The rims arerusted away. The centers are there, they are cast iron.
  3. W

    Rear rims

    Looking for rear rims for a WC road patrol grader. Thanks
  4. W

    Transmission snap ring

    Forgot to add it's for a massey ferguson 35. Thanks
  5. W

    Transmission snap ring

    This snap ring is about 1/8 inch wide. Been running into roadblocks trying to find one that is that wide.
  6. W

    Transmission snap ring

    Looking for the snap ring that holds the front gear on the counter shaft, part number is 195497M1. Everyone advertised them online, but when you call there discontinued. Looking for a good used one or if some one has a new one. Thanks Rod
  7. W

    Ford 600 top cover adjustments

    Everything came from Dennis Carpenter
  8. W

    Ford 600 top cover adjustments

    Hey Dean I replaced all that with new and still run out of threads on the turnbuckle.I have done several of these for customers but this one is kicking my but.
  9. W

    Ford 600 top cover adjustments

    I was double checking when i took the picture, I had the draft control lever down and the position control lever to the top just like the IT manual shows.
  10. W

    Ford 600 top cover adjustments

    Need some input, replaced everything that was worn, trying to adjust the draft control, turnbuckle is extended out as far as it can go and my gap is 498 thousands, book says 397 thousands. Any help of what I'm missing here thanks.
  11. W

    massey 35 hydraulics

    The 3 point lifts and lowers and the position control works, problem is when lowering it stops about 3 inches from the bottom. Try adjusting and moving the levers nothing helps. Any ideas. Thanks Rod
  12. W

    Distributor Breaker Plate Melting

    That breaker plate from Atlantic has been a problem for years. The points are not permanently attached,they put the points on the center pin put it in the plate and expand it. You have to destroy the points to get them off, the new points you have to make the hole bigger to fit, yep a real...
  13. W

    B.F. Avery and sons

    just purchased this tractor, look just like a cletrac general, the serial number is stamped on the top frame rail toward the rear, any help identifying it or the year would be appreciated. Tha serial number is 5A-409. Thanks
  14. W

    Bantam tractor information

  15. W

    One arm loader w/NAA brackets

    Hey Ultra Dog what is the difference between the Naa brackets and Hundred series bracket. Thanks Rod
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top