(800) 853-2651
SHOP NOW

Recent content by zeked

Yesterday's Tractor Forums
  1. Z

    Non-Sherman transmission

    It is definitely a Howard. Is it worth more in the 46 or as a separate item?
  2. Z

    Non-Sherman transmission

    In addition to the 1+3 std transmission
  3. Z

    Non-Sherman transmission

    I have a 46 2n with a 2 speed transmission. It shifts on the right side of the tractor opposite side of the pto engage lever. Any ideas as to what this is?
  4. Z

    Free 8N, // How 'free' is free ?

    No chance the rear tires are turf ????? Good luck with it Zeke
  5. Z

    governor too tight

    Thanks, James....I think I’ll tackle it when we get snowed in.....
  6. Z

    governor too tight

    How hard was it to refurbish the governor? If rebuilding a carb is a 3 out of ten? My 2N runs well but is a little wonky and I was considering rebuilding the governor Thanks Zeke
  7. Z

    solenoid and starter engages when it should not

    I have an extra solenoid free if you want it
  8. Z

    3pt chatter. (2N)

    Ok. Thanks. No rest for the wicked😳
  9. Z

    3pt chatter. (2N)

    When I pick up an implement with my 2N the lift arms chatter then lift to full up. The arms work ok after that but there is still chatter lifting from full down. Where do I start? I bought all of the recommended manuals but don’t see a definite answer. Can you talk me out of taking the...
  10. Z

    2N carb problem Again

    Thanks for the helpful suggestions. It turns out that it was a main jet problem all along, I appreciate the help Zeke
  11. Z

    2N carb problem Again

    Oem marvel Nice and clean
  12. Z

    2N carb problem Again

    My 45 2N starts and idles beautifully but when I put strain on it it stumbles until I crack the choke I can keep it running but have to fiddle with the choke ALL the time Any ideas? Firing orders are correct manifold was taken off and regasketed I have messed with the adjustment...
  13. Z

    Continental Belton Auger (seal)

    I have a Continental Belton Model QP post hole digger attached to my '39 Ford 9N and it leaks around the output shaft. The C-B part number is QP205 but I haven't been able to cross reference it. Does anyone know the modern seal number for this part? Thanks Zeke
  14. Z

    NEW ZANE THANG WEB SITE URL

    Grandpa, If it would help Zane?s family. And provide a needed tool for the forum folks, please pay them a visit. BTW I have Zane?s cornbread recipe if anyone wants it. (Ot) Zeke
  15. Z

    9n,2n starters-are any of them 12 volt??

    But ya don?t need one. A good 6Vt. Will turn to beat the band on 12Vt. Don?t run it all day 😊
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top