560Dennis
560Dennis
- Location
- Madison,Ohio
How much time do you put into the cleaning of your parts ?
Hopefully enough. I glass bead everything. When I did the calipers I took them completely apart and put old used pistons in for "plugs" and taped them in so to keep powder out of the seal groove.
If I don't get to coat something right away after blasting sometimes I have to put the part(s) back in the cabinet and hit them again right before I coat them.... Not always. I've had stuff sit over the winter and be fine. and I had stuff that flash rusted in a couple of days between blasting and coating. I blow everything off just before coating, and sometimes I wipe it down with Eastwood's "pre" cleaner. On those calipers or anything else that "lives" in oil, brake fluid, etc I toss in the oven and bake until the parts quit smoking then I know I ve gotten the oil etc out of the pores.
If I don't get to coat something right away after blasting sometimes I have to put the part(s) back in the cabinet and hit them again right before I coat them.... Not always. I've had stuff sit over the winter and be fine. and I had stuff that flash rusted in a couple of days between blasting and coating. I blow everything off just before coating, and sometimes I wipe it down with Eastwood's "pre" cleaner. On those calipers or anything else that "lives" in oil, brake fluid, etc I toss in the oven and bake until the parts quit smoking then I know I ve gotten the oil etc out of the pores.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy