Engine stand adapter plate for the ford 8N

[GhostCommander]

I was wondering if anyone had a template or actual adapter plate they either can give me dimensions for or possibly sell

 

[soaked]

Hi GhostCommander,
Welcome aboard!
This works good, only 4 holes to drill

 

[GhostCommander]

What brand is that stand? And am I seeing the fingers of the stand actually bolt to bell housing and I just need to drill thru the finger and bolt the plate to the fingers and then the plate where the fingers attach?

 

[GhostCommander]

Hi GhostCommander,
Welcome aboard!
This works good, only 4 holes to drill
View attachment 161565

Hi GhostCommander,
Welcome aboard!
This works good, only 4 holes to drill
View attachment 161565

See my last comment

 

[soaked]

Yes fingers bolt to block, none in oil pan.

Yes two middle bolts attach to the stand, letting the flatbar outside bolts position the lower fingers.

 

[GhostCommander]

Thank you very much

 

[Hobo,NC]

I was wondering if anyone had a template or actual adapter plate they either can give me dimensions for or possibly sell

I over complicate things. I wanted full access to the rear of the crankshaft plus get the engine up higher to work on. I used a treaded transfer screw set to transfer to a 1/4" plate.