Jet Star PTO output shaft.

[molinegb]

Does main pto shaft and clutch pack have to be removed to change the pto output shaft? Someone cut off the output shaft. Anyone ever done job? Looks to have a big nut holding gear in place.

 

[Oakridgewelding]

I can't answer your question tonight as my book is over at the shop. If I get there tomorrow I will try and look. Off the top of my head I think yes, but not exactly sure.

 

[NY 986]

Does main pto shaft and clutch pack have to be removed to change the pto output shaft? Someone cut off the output shaft. Anyone ever done job? Looks to have a big nut holding gear in place.

Did someone cut it or was it a clean break? I've seen that happen.

 

[molinegb]

Did someone cut it or was it a clean break? I've seen that happen.

Looks like torched. Drawbar also then welded to hangar.

 

[shaun wallace]

I know that have to on a 5 Star and M5.

 

[Alan K]

I know that have to on a 5 Star and M5.

Good to know. I wondered about that. I have an M5 to do lol.

 

[molinegb]

Also have a 5 Star diesel on that snapped half off running a mix mill. Have looked into a wrecked M5. No room to work unless pto shaft pulled. Later supers had a snap ring rather than nut on inside. Guess depends how shaft slides out on bearing.