hitachi dx40m dozer manual

[Toddysdx40]

I also need this manual in pdf format, can someone send it to me at [email protected]

txs

Hey mate did you ever get hold of that manual for the Hitachi DX 40? I’d love a copy if you did would be appreciated greatly.

 

[Toddysdx40]

I have a DX40M and I am desperate to get a service manual or some info. I have sourced a parts manual from Kent Braugh in Tx but I cannot find anywhere including Hitachi in Australia what type of oil in the oil clutch, final drives and the gear box. Because it is a direct import they refuse all information. The number on the hydraulic filter is another mystery.
Regards Russell

Hey mate did you ever find out the info on the DX 40 you were looking for? I’m chasing the same info and parts manual workshop manual. All of the above if you had any luck, I’d appreciate it. If you let me know maybe I can get some info off you

 

[Toddysdx40]

Do you still have the dx40 manuals as pdf

Did you ever get that DX 40 manual? I’d really appreciate a copy if you did. Cheers mate.

 

[Jim.ME]

Did you ever get that DX 40 manual? I’d really appreciate a copy if you did. Cheers mate.

If you click on a person's avatar, beside their post, most will show you when they were last seen (signed in here). A few have decided to turn that off so no one can see when they last signed in or if they are currently online here, top secret missions apparently.

In this case most if not all the guys in these old posts you are bringing to the top have not been around for years, so getting an answer from them is highly unlikely. This is even more true given the forum software changed at the end of 2023, which means they would have to sign in on software they have not used.

 

[Toddysdx40]

Haha cheers for the heads up mate I’m new to this forum stuff. How do I put a thread up so everyone on the forum can see? I can’t even figure that out?

 

[Jim.ME]

Haha cheers for the heads up mate I’m new to this forum stuff. How do I put a thread up so everyone on the forum can see? I can’t even figure that out?

Near the top on the right of every forum page here is a red Post Thread button click on that to open the form to start your new thread.

As far as one place everyone here where everyone will see it is hard to say as not everyone checks every forum here. The discussion forum you are in now (Crawlers, Loaders, Dozers and Backhoes) is likely as good a place as any here for the info you are looking for; it will get the most attention here where those interested in this type of equipment follow..

Have you tried joining the Heavy Equipment Forums website? You may have better luck there than this antique tractor site that is geared heavier to farm and turf.

What is your general location in this wide world? Your posts don't read like common USA/North American greetings, more like Austraila/New Zealand.

​

edited to add picture

 

[Toddysdx40]

cheers for the run down mate. And yes down under is where I call home can’t beat the Aussie weather

 

[Jim.ME]

cheers for the run down mate. And yes down under is where I call home can’t beat the Aussie weather

Good luck with your search.

Best regards,

Jim