AZ GARY

Member
We have a hand start JD H. Its hard to start cranking, towing
it, it fires right off. The magneto has been rebuilt and we have good spark to the plugs.
The 3 way valve has been replaced with a simple shut off so we have good gas flow to the carb.
We haven't done any thing to the carb is there a needle vavle we could open, would that do any good?
 
There should be an idle screw if that’s what you are asking? Open it a 1/4 turn more (counter clockwise) see if that improves the starting

Make sure it is sealed up with good gaskets another symptom an air leak would be starting when you are pulling it because it’s pulling more air in the leak can’t keep up and the carb will work then. So gasket at manifold to block, gasket at carb to manifold, is the throttle shaft on the carburetor loose to leak air in? Couple things to check

New gaskets if you take them apart silicone will just cause you trouble spend the 2 bucks
 
Could have crack around center block stud allowing coolant seep during storage as mine did causing hard initial start. How does it restart?
 
We have a hand start JD H. Its hard to start cranking, towing
it, it fires right off. The magneto has been rebuilt and we have good spark to the plugs.
The 3 way valve has been replaced with a simple shut off so we have good gas flow to the carb.
We haven't done any thing to the carb is there a needle vavle we could open, would that do any good?
I have a 41 H hand start also.
I barely open the throttle on mine.
I do mean barely.
Give it full choke and crank til it fires and open the choke.
Have to play with the choke a bit as I throttle it up.
 
Hopefully you got it dialed in and fired up. Not much help here, since the one I had was a '42 and it was electric. That helped a little with any weak mag problems, but it still liked having the fuel mixture right.
 

Attachments

  • 1942DeereH.jpg
    1942DeereH.jpg
    219.3 KB · Views: 0
Are you sure the impulse is locking. I had a early styled B that had a weak impulse lock. When hand starting, I had to set the throttle at idle, hold the choke with my left hand and just slowly palm it over, opening the choke when it fired. If you spun it fast it would not start.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top