A mini starter is a modern gear reduction style like used on most current cars. The V8 version is readily available and would physically bolt on but has the wrong number of teeth (10 instead of 9 needed for a flathead 6). These guys claim to have what you need.
The original starters for Ford cars/trucks/tractors of this era bolted on from the front but have a Bendix behind the flywheel. The issue is that an N tractor had a starter on the left side while the V8 and I6 had a RH starter. There is a cavity for it cast into the tractor bellhousing. So Funk had to figure out what to do about that. Modern 8N V8 conversion kits have you cut a hole in the tractor bellhousing on the right to clear the starter drive but you have a hole into the clutch cavity that you have to deal with sealing. Funk chose to create a starter that was more like a later (60s-70s) starter in that the Bendix came back not forward to engage the flywheel. All original V8/I6 flathead starters need a support forward so that they don't break noses. On my 2N V8 conversion I cut the bellhousing, but when I rebuilt as an 8N I used a mini-starter instead of the original style. Attached pics show an original N/I6/V8 style starter, a Funk starter, and a gear reduction style. Maybe that helps.
Edit-added a pic on my 2N V8 with starter drive.
Early Ford High Torque Mini Gear Reduction Starter
Use these brand new high torque starters on your older Ford vehicle to provide faster and better cranking power. The starters for the Y block and FE blocks will replace the original long shaft starters and will be a two bolt mount that replaces the factory three bolt mounting. For the...
www.qualitypowerauto.com
The original starters for Ford cars/trucks/tractors of this era bolted on from the front but have a Bendix behind the flywheel. The issue is that an N tractor had a starter on the left side while the V8 and I6 had a RH starter. There is a cavity for it cast into the tractor bellhousing. So Funk had to figure out what to do about that. Modern 8N V8 conversion kits have you cut a hole in the tractor bellhousing on the right to clear the starter drive but you have a hole into the clutch cavity that you have to deal with sealing. Funk chose to create a starter that was more like a later (60s-70s) starter in that the Bendix came back not forward to engage the flywheel. All original V8/I6 flathead starters need a support forward so that they don't break noses. On my 2N V8 conversion I cut the bellhousing, but when I rebuilt as an 8N I used a mini-starter instead of the original style. Attached pics show an original N/I6/V8 style starter, a Funk starter, and a gear reduction style. Maybe that helps.
Edit-added a pic on my 2N V8 with starter drive.
Attachments
Last edited: