I just bought a piece of pipe that was Cat 1 ID and Cat II OD. then I just cut off a piece to fit the implement Cat 1 pins and leave them on that implement. Cheap works well. Anything 3pt I build, I make sure it fits my quick hitch.
I went that way too because most of my old equipment wouldn't accept to top hook. I painted lines on the spreader bar so I could match it to various width gear easier. So far im happy.I just started using a Pat’s Quick Hitch this year. Two separate pieces, one for each arm. Adjustable spreader rod to lock the arms in place. You hook up the top link after the arms lock in. It probably isn’t as strong as the one piece ones, but is more adaptable to different pieces of equipment.
That's why Pat's quick hitch adapters are the way to go..each lift arm remains independent so you can match up to any implement that has lift pins. I have Pats on all my tractors that don't have moveable lift arm tips. I doubt that any 2 of my 3 pt. implements have the same spacing.A common complaint with quick hitches is they do not fit all equipment properly as there can be slight differences in the hitch points, the top link one is often an issue it seems along with width at the lift arm pins.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy