Search results

  1. B

    Tie rods for Allis Chalmers D14

    The tie rod ends were worn out on my AC D14. It has standard steering but steered fairly easy with the old tie rods. I tried two different after market suppliers. The tie rods I received from both of them make the tractor really difficult to steer. Are tie rods from an AGCO dealer still...
  2. B

    Replacement seat pan for Massey Harris 30 Row Crop

    I'm looking for a replacement seat pan for my Massey Harris 30 Row Crop. It is a two bolt pan. Bolt holes are 3.5" apart, center to center. I've only been able to find one bolt replacement pans online. Can someone point in the right direction. Thanks, Bill
  3. B

    Allis Chalmers D14 Power Steering

    Hello Everyone, I have a 1957 Allis Chalmers D-14 with manual steering. I'm wondering if it's possible and feasible to add power steering to it. If so, what would it cost for the parts and pieces and to have someone do it., as it's above my skill level. I would appreciate your input. Bill
  4. B

    Massey Harris 30 PTO Shaft Felt Washer

    Hello All, My Massey Harris 30 PTO has a felt wiper to ext to the oil seal on the shaft. That washer doesn't seem to be available any longer. Can anyone tell me where I can buy felt material to make a seal? My parts manual shows the seal as 5/16" thick. Thanks, Bill
  5. B

    Massey Harris 30 PTO oil seal

    Hello All, I'm in need of the lipped oil seal for the PTO on my Massey Harris 30. Can anyone point me in the right direction? Thanks, Bill
  6. B

    BOLTS FOR FRONT WHEEL WEIGHTS ON MY ALLIS CHALMERS D14

    Hello All, I'm looking for the bolts for the front wheel weights on my AC D14. I need 3. Can anyone point in the right direction? Thanks, Bill
  7. B

    D14 Starter

    Hello All,My D14 had been converted to 12 volt before I bought it. Yesterday, the starter wouldn't work. I removed it and found the nose cone broken off. I'm wondering what caused this. I read somewhere that not being installed correctly could be a cause. I saw something about shims. I would...
  8. B

    Farmall 340 Row Crop Battery Box Lid

    I need a battery box lid for my Farmall 340 Row Crop - Gas engine. The battery box sets behind the operator's seat. I'm told that the originals corroded badly and to find a used one would be rare. Is there anyone making a replacement or reproduction lid for this application? Should there be an...
  9. B

    Aliis Chalmers D-14 Lubricant and Transmission and diffe

    The rear end on my D-14 was noisy at road speed (10-12 mph).I took it to an AGCO dealership for repairs. They went thru it and replaced some worn parts and bearings. They put a low multi- viscosity lubricant in it similar to motor oil. Can't remember exact viscosity.They said that's what...
  10. B

    Allis Chalmers D-14 fenders

    All you Allis Chalmers Guys, Will D-15 fenders fit on a D-14?
  11. B

    Farmall 340 cylinder compression test

    Hello All, I'm trying to determine what is causing the oil pressure loss on my Farmall 340 gas engine. It shows about 41 psi cold. As engine reaches operating temperature it drops to 10-15 psi. A couple of questions: 1. One of the things I have checked is the cranking compression in all 4...
  12. B

    D-14 Radiator Shell Seal Part# 229752

    I have the radiator shell and radiator off of my D-14, ready for reassembly. There are two shell seals that fit between the shell and radiator at the top left and right. I have the original ones, but not in very good shape. I'm unable to locate new ones using the AC part #. Any suggestions...
  13. B

    D-14 serial number

    AC Experts, I bought a D-14 recently. The location on the torque tube where the serial number should be is pitted and the serial number is gone. Can the engine serial number be used to determine year of manufacture? Can the engine serial number be used to determine tractor serial number...
  14. B

    D-14 Headlight Bulb Repacement

    I recently bought a 1957 D-14. Previous owner had converted it to 12 volts electrical system but had not completed wiring and bulb changes. I need to replace the 6 volt bulbs in the headlights with 12 volt bulbs. I pulle the reflector can out of the housing, but how do removed the headlight...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top