(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. G

    3400 gas fuel ines

    I did a tear down of a 3400 gas about 10 years ago finally finishing up restoration. But cannot find any diagram or photo of fuel line routing. I have to make the lines and don't know where each goes. Any help would be appreciated.
  2. G

    Crank endplay

    Rebuilding the 8n and found that there is too much endplay. I need to take up .008 to .01 of the endplay. Adjusting the play in the thrust bearing cap will not do it. Any answers would help.
  3. G

    8n steering shafts

    what is the difference between the early and late 8n steering shafts?
  4. G

    steering shaft ball and nut

    I have disassembled the nut and balls from the steering shaft on my late model 8n. I seem to have a problem getting all 60 new balls into the nut for assembly. Is the a method to doing this?
  5. G

    8n rear axle

    When I removed the rear axles you could see where they had been rubbing. I measured another axle I had and noticed that both out of this tractor were about 1/16 shorter. Is this a problem, should they be replaced? I don"t see any wear on the splines.
  6. G

    vc battery cover latch

    I looking for a latch for the battery cover on Case VC or a photo. I just received a cover but it was missing the latch. Maybe I can duplicate it with a photo.
  7. G

    case VC

    I have a Case VC that have been restoring for quite a while. have noe gotten to the electrical and cannot determine if it is to be a positive or negative ground. With the price of a regulator I don"t want to make a mistake.Any help would be appreciated. Also looking for the battery cover, it...
  8. G

    what is it?

    I"m restoring a case tractor. Not quite sure what model. There are a couple of levers that were not attached to anything when I started to take apart. If anyone could help it would be appreciated.
  9. G

    reverse idler

    I was wondering if anyone knows what the tolerance is on the reverse idler installed in the transmission. The case in my tractor is well worn and i need to make the thrust washer to compensate for the difference.
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top