(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. C

    adjusting farmall 300 governor

    what is the correct way to set the throttle shaft connecting rod on a farmall 300 governor
  2. C

    adjusting farmall 300 governor

    what is the correct way to set the throttle shaft connecting rod on a farmall 300 governor
  3. C

    M hitch

    Can a hitch for a M be made to fit a 300 with out quick hitch
  4. C

    Galvinized wheels on farmall 300

    Did the 300"s come with Galvinized wheels. If so was it front and rear or just rear?
  5. C

    IH governor

    I have a Farmall 300 that the governor seems to react slow. Iam going to check for internal wear and free play in the linkage. but I want to know if I should install a Stock replacement spring or is there some thing better if so where can I get one
  6. C

    Organic vs Ceramic

    What clutch is better for pulling. I always perfer organic for trucks, used for work not talking about pulling trucks. but am open minded when it comes to pulling parts. being used in a Farmall 300. Most of the pulls a go to are dead weight pulls but I plan on some sled pulls next season.
  7. C

    Farmall 300 clutch

    Need a new clutch full disc or 4 pad which is better for pulling/work ?
  8. C

    300 T/A

    Works in 1st and rev with no load. But slips under load and in higher gear. Must be the clutch right? But there is a grind that I can feel in the lever when engaged. Is that the ramp assy.
  9. C

    farmall 300 ign. timing

    On the the tune up specs for a super h it show the spark to occur on the 1st notch of the pulley Is it the same for the 300 also at that mark is that spark for cylinder #1 because I found mine to be timed for #4 at that point Thanks
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top