(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. B

    moving to wisconson

    daughter said we are moving to ashland county wi when school lets out at the end of may will be bringing my To 30 fergy with me it is restored and looks and runs like new Just wondering if anyone on here is from that area we are coming from utah Will put the old girl back to work on a real farm...
  2. B

    freeze plugs in a 172 cu in, motor

    any one have a easy way to install new freeze plugs in a 55 800 172 block.Been helping a friend on his 55 ford 850. It over heated do to bad cooling system removed all plugs and all the other parts and flushed out the block. Never saw that much sludge in a motor but its clean now need to get it...
  3. B

    installing freeze plugs in a 172 cu in. motor

    anyone have a easy way to install the plugs back have the old ones out and block is now nice and clean.THANKS BILL
  4. B

    HAPPY HAPPY HAPPY 8N

    was able to get outside this morning to check on the 8n tractor i have been rebuilding first time in 7 days it was 16 degrees outside and in the tent garage the 8n is in turned on the key gave it a little gas pulled out the choke pushed starter and it turned rite over and started slowly pushed...
  5. B

    paint on gen and starter and rims

    doing a complete rebuild on my 52 8n what is the original color for the generator and starter i have them off so i could do a good job painting the engine have seen them painted red and some black also have the original hat rims on the back should they be painted the gray like body have seen...
  6. B

    carb on a 52 8n

    doing a total rebuild on this tractor it had no carb on it when i got it but came with a large box of parts in that box is a tsx 241b carb in a lot of pieces also came with another parts tractor a earlier model 8n with front distributor and has a tsx 33 carb on it is there any difference in the...
  7. B

    need info on 69 1020

    going to look at a 1969 1020 says it has water in the oil does this tractor have wet or dry sleeves this is first john deere i will work on i like to restore old tractors have done ford 47 2n ford 56 850 oliver 69 1600 farmall 47 bn ferguson 52 to30 and just finished a farmall 55 300 row crop so...
  8. B

    farmall 300 finished

    Want to thank everyone for their help when i was working on it bought it on feb.3 2014 got it home i month later after all the snow was gone was sitting outside for at least the last 4 years since the father died no longer used or wanted motor stuck flat tires no battery but i got lucky when i...
  9. B

    farmall 300 running a little rich

    can i lower the level of gas in carb by adjusting float to correct this also serial # of tractor is 6437 DSJ and block serial # is 6440 D would this be original motor Thanks Bill
  10. B

    farmall 300

    serial # on tractor is 6437 DSJ and block serial # is 6440 D would this be the original motor it is a 169 motor also it is running a little rich can i lower the level in the carb to correct this Thanks Bill
  11. B

    timing on my farmall 300

    morning turn the rotor no movement removed the distributor after marking the location of the rotor took it apart and it was stuck because of all the rust springs are fine will clean everything should i put a lite coat of oil or grease on the weights before i put it back together this tractor sat...
  12. B

    timing on my farmall 300

    finished the rebuild on my engine finally got it running it has new rings and bearings and all new gaskets no leaks fresh antifreeze oil oil filter clean gas tank rebuilt carb starts easy and runs smooth set the idle at 350 to 400 rpm on the new tach and used timing light to set timing at tdc...
  13. B

    oil pump on 300

    i am ready to install the oil pump on my farmall 300 169 cu in motor should i prime it and if so what is the best way to do it? thanks Bill
  14. B

    farmall 300 radiator hoses

    does anyone know who has the hoses for the farmall 300 tractor YT does not have the right ones parts book shows bottom hose as 362 833 R1 is it one piece or metel tube with rubber ends?
  15. B

    lever on bottom of farmall 300

    while cleaning the bottom of tractor to get ready for painting found a lever in the middle of area under the power take-off drive parts catalog calls it seasonal disconnect coupling shifter my question is it something i should use and why? Thanks Bill
  16. B

    rod bearing size

    will be checking my rod bearings on my farmall 300 now that i have got it unstuck what size would be standard for the crank rod to measure so i would know what bearings to order if i have to get new ones? only one piston was stuck do to the fact no one covered the exhaust with a can and water...
  17. B

    farmall 300 engine rebuild

    just bought this tractor engine is stuck working on getting it loose serial # on tractor is 6437 dsj engine serial# is 6440 d know this stands for high altitude pistons if i have to replace sleeves and pistons does anyone still make this type piston and what is the best way to pull the sleeves...
  18. B

    trying to find year for 300 tractor

    looking at a farmall 300 with serial #6437 dsj found this # on side of clutch housing can someone tell me about this tractor have rebuilt ferguson and ford but this is first farmall
  19. B

    pto shield

    removed pto cover to install overrun coupler on my to 30 i would like to put a shield over it does anyone make one for this tractor have been looking but have not seen any will i have to make one thanks for any info Bill
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top