(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. S

    D-4 parts machine question?

    Have a 1952 D-4 and broke the shaft that goes from the crank through the clutch. Looking for parts and found a running 1947 D-4. Will most parts interchange, powertrain, undercarriage etc.. is it worth buying as parts machine? Is this shaft available new? any idea what they cost?
  2. S

    D4 cat 7U clutch rattle

    Was pushing brush and suddenly got a loud rattle from clutch housing. Managed to return to my truck but clutch was not engaging or disengaging properly. Removed the top cover over clutch housing and at idle the yoke assembly was vibrating wildly. if I pushed the clutch lever fully forward the...
  3. S

    4430 hyd chatter

    run a 4430 on a baler and loader. the hyds chatter and are very slow. was told I could run a line from the main pump directly back to spools and it will help with both problems. it takes the supply pump in trans out of the loop.any idea if this works or is a bad idea? was also told it could be...
  4. S

    john deere 567 baler error E2 04

    Book says this error code means a short in twine actuator harness. I peeled the plastic cover off all the wiring and tracked it back to actuator, no bare/broken /damaged wire. Used the bypass for the manual switch to control actuator and it works fine. could this be a glitching monitor? Also...
  5. S

    350 case-leaking final drive

    Am looking at a 350 crawler loader. looks ok but there is oil on the outside of left rear sprocket. hasn't been used for years. Is this a sign of a major problem in final drive or just a seal. If you tighten the nut on the outside of sprocket will it snug up the leaking seal? doesn't seem to...
  6. S

    4430 hyd creep

    have a new to me 4430, swapped out the JD hyd couplers for pioneer. now when I have it on 567 baler the hyd won't hold the door closed, and it will actually creep open. when I use loader with same valves the tilt won't hold either. did I miss something in swap or is it further up the...
  7. S

    4430 hyd

    have a new to me 4430, swapped out the JD hyd couplers for pioneer. now when I have it on 567 baler the hyd won't hold the door closed, and it will actually creep open. when I use loader with same valves the tilt won't hold either. did I miss something in swap or is it further up the...
  8. S

    4450 killing batteries

    I have a 4450 JD that has started to kill it's batteries if it sits for more than a day or so. Any suggestions on where to start looking for shorts? Put 2 new batteries on and still doing it. was told if I disconnect battery and there is a slight spark it means there is a draw. Is this...
  9. S

    jd 6400 hydraulics

    other than linkage what would cause a rear spool on a 6400 to quit working? Had one quit a while back and have been getting along with only one. Now the pump seems to surge when warm and tractor idling. Spool still working but would like any input on what to look for before i take apart was...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top