(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. C

    IH 464 Bewildering problem

    Just put a clutch in a 464, with no issues, pretty straightforward project. Stuck it all back together and everything is fine...except...the steering is backwards. There are 4 hydraulic lines that run to the front end. Two of them are to the cooler. Two others are for steering and they are...
  2. C

    Public Service Message

    Just want to remind everyone that even friendly forums such as this can draw the attention of slimeballs. Beware of scammers and stay on your toes. I very narrowly dodged an attempt in my eagerness. They are not only on ebay and marketplace, they are here.
  3. C

    Int 464 head scratcher of a fuel problem

    This has me stumped and any help is greatly appreciated. Gas engine 464. It runs great in all ways. Couple months ago it developed this problem of quitting heading uphill. Runs great downhill and level. Have cleaned the entire fuel system, to the extent possible. Fuel flow to the carb is...
  4. C

    Big MO 500 PTO question

    I have a Big Mo that apparently was set up for backhoe or something. It has a large hyd pump on the rear and no PTO. I would like to find the stuff and install a PTO if this is doable. I understand that much Jetstar stuff will fit the MO, so would a PTO from a Jetstar work? Or would...
  5. C

    IHC TRACTOR QUESTION

    Need some advice from those who know. I have a 464 IHC without the hydraulic remotes. I have found the remote valve etc from a 66 series tractor, but the part number etc is not available to me. Does anyone know if this valve from a 66 series will fit my 464. Help is much appreciated.
  6. C

    Anyone familiar with Woods L306 mower?

    I got this mower used and it works fine and everything finally got sorted out and adjusted. But it is leaving two unmowed streaks which tells me the there is a gap between the three blades. The longest blades I can find online are said to be 24.5 inches, which is .5 inch longer than what is on...
  7. C

    Belly mower belt farmall c

    I have a woods 306 belly mower mounted on a Farmall C and need some help with the belt. I have to Woods manual but there is one thing I am apparently not understanding correctly. It says when the belt leaves the center puley and travels to the rear to the left hand idler, the belt should have...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top