Search results

  1. A

    1086 Low Pressure on Remote(s)

    In follow-up to my post earlier this week about the problem of not being able to lift the disc behind my 1086, the suggestions were to get a pressure reading and if possible a flow-rate. Couldn't get a flowmeter but did get the pressure gauge. Both remote outlets only generate 1000psi...
  2. A

    1086 Won't Raise Load On Remotes

    My 1086, s/n 60522 with open-center hydraulics, is having an issue with raising my disc when hooked to the remote. Here is what has been done/checked so far: - Fluid level checked and topped off - Recent hydraulic filter change (roughly 10 hours of use since change) - Worked when using my...
  3. A

    JD 6600 unloading auger drive

    Ok, so I am almost done with harvesting my beans and the bearing on the shaft that is driven by the belt under the seat goes to pieces. I don't think that pulley has been off since the day they built the combine. Does anyone have experience with this particular repair that could share some...
  4. A

    JD 6600 Combine Left Brake Drum Removal

    I am trying to remove the left hand brake drum on my 6600. I have the axle shaft removed already but I am looking like a monkey doing a math problem in trying to figure out this drum sitting between the clutch housing and transmission case is supposed to come off. I have seen a few posts about...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top