(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. S

    2010 hlr lube line pressure

    Can anyone explain to me how the pressure regulator on a SN>45340 2010 HLR transmission actually works? Specifically, how does it regulate the lube oil pressure? According to the spec sheet, both the cooler and lube oil are controlled by the adjustable 65-psi relief valve, but I don't...
  2. S

    2010W HLR filter housing elbow

    Hi, The parts catalog (PC-731, pg 102) lists two version of the transmission filter housing, an early one and a later one (>45340). However, it also lists all the late model parts as a substitute for the early model housing, so basically you can swap out an early model housing with a later...
  3. S

    2010 hydraulic backpressure

    My early model 2010 Wheel (industrial backhoe) has had a variety of over-pressure problems ever since i ended up with it: leaks, blown seals, banging in the lines, etc. It's an H-L-R transmission with power steering. I teed in a pressure gauge at the output of the cooler, and found that once...
  4. S

    2010 throttle rod length

    I'm having a devil of a time getting the throttle on my 2010 Wheel adjusted correctly, and while the first step of the procedure has you "adjust the rear control rod until the governor control lever contacts the firewall", there is absolutely no way this is possible on my tractor while the front...
  5. S

    2010 battery access

    This might be the worlds dumbest question, but how am i supposed to get to the battery on a 2010 after a (720) loader has been installed? The two main 3/4" supply/return hoses come out of the control valve right past the battery compartment, and there is not nearly enough slack or wiggle room...
  6. S

    Unidentified 2010 Part?

    This part (allegedly) came off an early model JD 2010 (with a 93 backhoe and 720 loader) but I can't find any information about what it is, what it's for, or what it's supposed to do. Based on the size/bolt hole pattern, it would seem like it should attach to the side frames, hang underneath...
  7. S

    2010 throttle linkage

    Hi, I have an early-model (gas) 2010 to which I'm trying to revert some of the neglect and abuse that's been done over the years, but I've run into a bit of a snag while getting the throttle put back together. The first step in the service manual procedure for adjusting the speed...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top