(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. T

    Fuel in crankcase, International 2400A

    I'm getting fuel in the crankcase... we changed the injector pump gasket but I'm still filling up after about an hour of running. Any suggestions where to go next? It has the D179 engine
  2. T

    2400A dipstick

    I'm looking for a dipstick for an international D179 engine. Can someone point me in a direction to find one? It's a new tractor to me and the only one I've found is on Ebay for 200 bucks.
  3. T

    Loosing hydraulic pressure???

    I have a Ford 3000... When I first crank it up, It takes about 15 to 20 seconds of lifting and lowering the lift lever before the lift will move the first time. After that it will work fine the whole time I'm using it. It has good lifting power and will hold anywhere between up and down. It is...
  4. T

    Hydraulic Fluid

    What fluid do you guys use?... I was picking up a lift cover gasket/o-ring kit today and my local Ford dealer asked my that question. I told him I was planning on using Supertrac from Tractor Supply. He told me it was to thin and would cause problems. I needed something thicker. Has anyone on...
  5. T

    Fuel Gauge reading backwards?

    I bought a replacement gauge cluster for my ford 3000. Everything works fine except the fuel gauge. It's reading backwards. I pulled the sending unit and it moves the needle just fine only in the wrong direction. I tried switching the wires on back of the gauge, but that only pegs it out on...
  6. T

    Removing valve seats in pump

    Is there something else I can use to remove the valve seats in a hydraulic pump without spending $65 on the tool? I hate to spend that and probably only use it once. The smallest bearing puller I can find is 8mm. I think the seats are 6MM.
  7. T

    Hydraulic pump lines on a Ford 3000

    I plan on rebuilding my pump over the Christmas Holidays. My pump has one screw in line and one press in line. My question is this, is the press in line only held by the o-ring? I don't want to break something getting it off..LOL
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top