(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. J

    M with dual loader

    I have a dual loader on my M. The single hydraulic bucket cylinder is bad. I believe it is a dual 250. Could anyone tell me the size of the cylinder that is used on the dual loaders.
  2. J

    JD #5 mower issue

    I was mowing with my jD #5 mower and the sickle stopped moving. The pto shaft going into the gear box was turning but nothing else. Could anyone tell me what probably is wrong and if there is a fix to it. Found out the chain was loose. Tightened it and it worked about 5 minutes. Then the shaft...
  3. J

    gearbox on John Deere no. 5 mower

    I was mowing with my jD #5 mower and the sickle stopped moving. The pto shaft going into the gear box was turning but nothing else. Could anyone tell me what probably is wrong and if there is a fix to it.
  4. J

    pto pump

    I have a 1948 M and and a dual loader on it. I want to replace the bad pto pump on the tractor. Any suggestions on what type and how big of pump to put on it?
  5. J

    tilt cylinder

    I have 250 dual loader and would like to put on a new tilt cylinder. It is a single cylinder and would like to know the size of the original cylinder. Thanks for any help
  6. J

    E10

    Can I run E10 ethanol in my 1948 M and my 1952 H tractors. Where I live it is very hard to find regular gasoline. Is there anything that can be added to the E10. Thanks for any advice
  7. J

    JD #5 sickle mower

    When mowing grass or brome with an H and a JD #5 sickle mower what works best: a sickle with a smooth or serrated sections? Or does it even make a difference?
  8. J

    H farmall

    Just bought a 1952 H farmall tractor. I am going to use it only in the summer for mowing(SD). What type of oil should I use in the engine and also what is the capacity of engine oil. THANKS FOR ANY ADVICE
  9. J

    Transmission leak

    I have a oil leak on my 48 farmall m tractor. It seems to be coming from the seal in front of the transmission. How much of a job is it to replace the seal? Also where can you purchase the seal? thanks
  10. J

    clutch

    I have a 1948 M and the clutch pedal is near the top of travel when released. Is there an easy way for a non mechanic to adjust the clutch so that it takes hold sooner when released? Thanks for any help or pictures.
  11. J

    Re: Farmall M Runs When Chocked - Need Help

    I have a 48 M also. The only thing that I can help with is that when you pull the throttle towards the driver it is at high throttle. Lever away from the driver is idle.
  12. J

    Add on 3 point now working

    After replacing the 2 inch cylinder with a 4 inch cylinder, my M and add on 3 point now lifts a 1300 lb. bale with no problem. With a loader on the front, the front end also stays down. Thanks for all the advice on my earlier post on this problem.
  13. J

    Synthetic oil

    I use 10w30 oil in my M farmall the year round. Is it okay to use Mobil 1 synthetic 10w30 in the tractor? Someone said that it might start better in the winter. Does anyone know for sure?
  14. J

    3point on M Famall

    I have an after market 3 point on my M farmall. It handles a blade fine but if I put on a bale fork and try to lift a big round bale, it will not lift it. My loader will lift a 1300 lb bale using the pto pump. The 3 point was attached to the belly pump first and then to the pto pump but...
  15. J

    M farmall belly pump

    How much oil does the M farmall belly pump hold and is there a check level plug for it? I have a service manual but it does not say anything about the belly pump.
  16. J

    Farmall M rear end

    After draining the rear end of a M farmall, I need to fill it. The fill plug is stubborn and will not come out. Someone told me that I could pull out the shifter and put the 13 gallons through the shifter hole. Will this work or should I keep working to get the fill plug out?
  17. J

    M Farmall question

    I know that when you drain the rear end of a M farmall, it takes about 13 gallons to fill it. My question is does the rear end, the transmission and belly pump run off the same 13 gallons? My other question is where do you fill it and how do you know when it is full? Any advice or pictures...
  18. J

    heater for winter starting

    I have a 48 m farmall. Is there any way to install a tank heater or block heater on it? Some winter mornings are zero or way below zero.
  19. J

    48 m tractor gear oil

    I have owned my 48 M for about 4 years and I am thinking about draining the rear end and adding 80-90 weight gear oil. I have been hearing about seal leaks after changing the gear oil. Is it wise to change it or let be? I use it for moving bales and snow in the winter (SD) and I have not had...
  20. J

    48 Farmall M

    How hard is it to put a new 3-4 gear in the transmisson on a 48 M? Does anyone have an idea as to the cost of the gear and the labor?
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top