(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. M

    Moline steering cylinder

    I have a moline 708 steering cylinder that leaks at the back end where the shaft moves in and out.All the years that my dad and I ran that tractor the leak was never an issue nor did we stop long enough to diagnose the problem.Now that I've just about finished restoration and want to sell the...
  2. M

    Moline 708 steering cylinder will not move either direction

    I've got a good tech manual and parts book as well.Thanks for your help.I appreciate it. Mark A.
  3. M

    Moline 708 steering cylinder will not move either direction

    valve assembly is out.I have removed the inner snap ring from the opposite end. Should the rod come out now?
  4. M

    Moline 708 steering cylinder will not move either direction

    I have the threaded cast plug out and the ball stud and ball bearings .The next part which is solid has a what appears as the head of a valve and is held in by a spring on back side which cannot be seen.Does this section come out of cylinder or is it the section that is welded to the tubular...
  5. M

    Moline 708 steering cylinder will not move either direction

    Are there any parts available for 708 steering cylinder.New or used?
  6. M

    Moline 708 steering cylinder will not move either direction

    I have threaded cast iron plug removed and everything in that end of cylinder is clean.The Flexure and ball stud shell are still in place.The valve is still in place and there is a spring holding it pulled up tite against valve spool.Is there a way to pull valve spool out in order to clean it.
  7. M

    Moline 708 steering cylinder will not move either direction

    Moline 708 steering cylinder dosen't move in either direction.Hydraulic pressure is close to specs.at remotes and steering supply line. With cylinder disconnected from left front wheel,I can get no movement from steering cylinder at all.Is my steering pressure bypassing somewhere inside cylinder...
  8. M

    Moline 708 steering cylinder will not move either direction

    Thank you for your help Moresmoke but I'm not through.Do you have time for a little more help with this 708 steering cylinder?
  9. M

    Moline 708 steering cylinder will not move either direction

  10. M

    Moline 708 steering cylinder will not move either direction

    I have 1700PSI + at remotes.With guage plumbed in series in steering cylinder supply line I have no pressure and with guage plumbed directly to steering supply port on hyd. pump I have 650 PSI +. Does this sound like with guage plumbed in series in steering supply oil is passing straight back to...
  11. M

    jd 345 engine surge

    I have new carb,new gaskets and all new fuel system including fuel pump. A slight bit of choke seems to help the surging. I replaced original carb because of old fuel/ gummed up carb,and yes I should have rebuilt JD carb.Before old JD carb was messed up with old gas,it never surged and had...
  12. M

    jd 345 engine surge

    I am having the same problem with surging on two JD mowers .One is a 125 with Briggs & Stratton engine and the other is a JD 345 lawn tractor with 24 HP Kiawasaki . Both tractors have new chinese carbs The JD 345 has all new fuel system.
  13. M

    mixing 930 front end with 1030 rear end

    I h ave a 930 with no 3 point hitch.I have bought the whole transmission and rear axle housing.with all the guts and feathers,including 3-point hitch.I wont to replace the 930 rear section with the 1030 rear section.Is this a workable match?
  14. M

    Case 930 3-point hitch

    I have a Case 930 with no 3-point hitch.I have located a 1030 transmission housing at a good price with all 3-point equipment intact.Will the 1030 3-point equipment work on my 930? Any and all help would be appreciated Thank You Mark A.
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top