(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. G

    12 hole deep wight bracket

    I picked this up at an auction recently, and I have never seen one quite like it. It is deeper than any other one I have, and has those two flat bars near the ends. Is this a factory bracket? The auctioneer had it marked as off a 1586. Thanks in advance for your replies!
  2. G

    2155 brake bleed problem

    Well, I was looking through the TM-4435 technical manual I have and came across this. Photo is of “Installing Brake Valve Assembly”. It even states that the gasket should have no holes as the brake valve is supplied with oil from the hydraulic reservoir. I’m still struggling with the brakes as...
  3. G

    2155 brake bleed problem

    All right guys, this is what I have done. There is no 4th line coming off the brake valve assembly. There is one line for the left brake and one for the right, as well as the tube going forward and up to the Y. Also, there is no removable plug on the top of the brake valve to check if there...
  4. G

    2155 brake bleed problem

    My first attempt at bleeding I did just as the owners manual suggested. Put a clear tube over the left bleed screw and submerged the other end in the bottom of the rear end down from the fill cap. I then opened the bleed screw about a quarter turn and left it open, and cycled the pedal for...
  5. G

    2155 brake bleed problem

    Please look at my last post. Thank you!
  6. G

    2155 brake bleed problem

    This fitting with tube is at the front of where the right shifter is located. Is this the supply source for the brake master cylinders? This tube goes up behind the dash and connects to the back of the green plastic Y. The front fork of the Y with the tube on it, goes up to the reservoir in...
  7. G

    2155 brake bleed problem

    Thank you. I will look into that
  8. G

    2155 brake bleed problem

    Thank you for the pictures and diagram, but they are different than what I have. I do have the Technical manual TM-4435 that is for the 2155 and 2355N tractors, but it really just says the same thing as the operators manual regarding bleeding the brakes. This is what mine looks like. A small...
  9. G

    2155 brake bleed problem

    I will post some pictures
  10. G

    2155 brake bleed problem

    I actually drove the tractor on and off the trailer and to where it is parked now under the shed. They worked good BEFORE I messed with it. Now, both pedals go down to the floor with no resistance. I haven’t tried bleeding the right one, only the left one. Maybe I should try the right one.
  11. G

    2155 brake bleed problem

    No, just black gunk.
  12. G

    2155 brake bleed problem

    Yeah, and it was pretty nasty. Did it when I changed the fluid and filter.
  13. G

    2155 brake bleed problem

    A little history on this tractor. I purchased from a local municipality that owned it since new. The nose of the tractor had been pushed back some and cracked the fuel tank. Some disassembly happened and then it was abandoned. I removed the nose, fuel tank, radiator, etc., and replaced...
  14. G

    2155 Hydraulic Pump Coupling Rubber Piece

    Well, I went to change the fan belt and a few hoses on this tractor, and decided to replace the rubber “carrier” for the hydraulic pump coupler since I had it apart. Boy what a job just to replace a belt. Anyway, I cleaned both surfaces and put it back together with the new rubber, and used a...
  15. G

    International 785 at what engine rpm is PTO at 540 rpm?

    Thank you JimB2!
  16. G

    International 785 at what engine rpm is PTO at 540 rpm?

    I have a tractor that is not common stateside, and I have been unable to get a paper owners manual for it. It has a tach that does not have an indication on it where 540 pto rpm falls. I’m wanting to use it to cut my hay with a Vermeer TM800, and don’t want to guess. Anybody have this...
  17. G

    JD 2155 seat cushions and trans dipstick location

    No, I have a 2240 and that is where it is. The floor boards are different though on the 2155. I am miffed on where else to look. I just don’t see anything like what is in that pic below. If someone could post a pic of the tube in that pic where it goes into the rear end, maybe I’m just not...
  18. G

    JD 2155 seat cushions and trans dipstick location

    It’s definitely a rubber cup plug. Kinda like a thimble with a flange around the top, put in upside down. I don’t want to remove it until I have something to put back in it incase I bugger it up getting it out. Tractor was bought new by the city and used at the waste water plant back when...
  19. G

    JD 2155 seat cushions and trans dipstick location

    Tractor is the later one. The plug is a sort of rubber one, and I agree, I would have thought it would be a steel or brass plug.
  20. G

    JD 2155 seat cushions and trans dipstick location

    Well gee wiz. I don’t have a dipstick there either, only a plug. Any other ideas?
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top