(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. S

    Cub 1054 help with drive

    I have a Cub 1054 which is about 5 years old. Worked great first 3 years. Last 2 problems with cutting new spindles and belt fixed. This year doesnt want to move if grass is even a little wet. Checked drive belt was shot. Replaced belt. No help at air. Any thoughts would be greatly...
  2. S

    TO20 original carburetor number

    Thanks to one and all for the help. Working on tractors without your help would be so much harder.
  3. S

    TO20 original carburetor number

    I have a 1950 TO20 and need to replace the carburetor. Mine is apparently off a Ford N type as the number is TSX33. My serial number is 21387 and it is a marvel schebler. 2 3/8 center to center on the mount studs The Ferguson number should be something like TSX????? Thanks...
  4. S

    Anyone with knowledge of MDAIRC carburetors??

    I need a replacement carb for my 1950 TO20. Amazon has a MDARIC HD for $89. Has anyone used one of these and what are your thoughts. Mine is not worth the total rebuilding cost that is why I am looking to replace.
  5. S

    What is this device used for?

    Thank you, good to get the answer from someone who has used them.
  6. S

    What is this device used for?

    Yes I agree not for plow. I have used my double bottom without them many times. I do have trailing arms which connect under the axel many times. Also they are not for the loader arms. I found a picture which shows the arms on another mount.
  7. S

    What is this device used for?

    I purchased fenders for my TO20 at a sale. They have a fitting on the mount that I have never seen. Can someone please tell me what they where used for. I suspect some type of implement mount. Just looked at a old video. Could these be whether arms for the factory front loader mounted...
  8. S

    How to post pictures

    Could someone please tell me the simple way to post pictures in the forum.
  9. S

    Polarize battery

    So I have looked everywhere and cannot find this simple information. When you polarize the battery is it done with the engine rumor not.? If not is the switch 9n or of? Or does it matter? Then how can you tell other that the spark that it is done! Thanks.
  10. S

    TO20 short to ground?

    No but thanks I will give that a try.
  11. S

    TO20 short to ground?

    I have a 1950 TO20 Ferguson. I have been working on a shorting out problem for some time now. I will do my best to keep this short but it goes on and on. If I engage the starter with the main switch on or off the battery goes immediately to 0 volts the starter does not engage. When I disengage...
  12. S

    TO20 generator terminals

    Well I removed both wires from the terminals. Wire brushed the area pretty well. This looks like it may be the original generator on my tractor. Still cannot se anything stamped on the generator. What if I jump started the tractor could I get a voltage reading from one terminal or the other to...
  13. S

    TO20 generator terminals

    How do I know which one is A and which one is F? There is a — cast into the case near one terminal but I see nothing else.
  14. S

    No spark at points need help fast

    So I was setting the gap on my points today, Massey Ferguson 245 gas. My help left the ignition switch on when he was turning the motor over to get the high spot on the disturber cam. When I put the feeler guage in I got a strong spark. Now I have no spark on the points when I crank the motor...
  15. S

    Clutch problems

    Success Thanks to all.
  16. S

    Clutch problems

    To begin with,yes the tractor sat most of last summer. Had to pull it to the shop to give the fuel system a going over. Next I am no mechanic by any means, but I am reasonable capable. Did a engine rebuild on my TO20 Ferguson with some book help. That all said looks to me like the bearing is...
  17. S

    Clutch problems

    1958 Cub. The clutch does not seem to be engaging? With the motor running if you push the clutch pedal in you cannot engage any gear. All it dose is grind. Stop the engine and you can shift into any gear. If you try to start the engine with it in gear and the clutch pedal depressed the tractor...
  18. S

    TO20 locked up n gears?

    So I tried to pull start my Ferguson. First second and third gears are locked up. Fourth gear will turn the motor over. Do I have something broken in my transmission?
  19. S

    Need help on 1958 cub. Dies without choke.

    So my cub would not start after sitting all summer. Pulled the carb Opened it soaked in cleaner for two days. Now it will start but dies the second the choke is shut off. I did not drain all the gas as only little was in the tank. Put about 1 1/2 gal of fresh in. Thanks for any help
  20. S

    6 volt wire??

    So I have heard there is special 6 volt wire that was used on spark plugs back in the day. My two older tractors have modern wire on them. Does this make a deference? Thanks for the help.
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top