(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. D

    784 PTO

  2. D

    784 PTO

    I solved my problem the thrust washer had wore into the snap ring and was hard to understand what needed to be done
  3. D

    784 PTO

    I'm replacing the clutch plates in the PTO which seems to be easily done, now I would like to replace the O rings and I would need some help with that, do I remove that clip ring and remove that gear, is that gear under pressure and needs to be compressed? Am I overlooking anything?
  4. D

    New Clutch

    All the parts are new, yesterday I removed some of the free play on the pedal I now have a half inch if that doesn't solve my problem I will do what is mentioned above, remove all free play. And no hydraulic clutch. Thanks to everyone, David
  5. D

    New Clutch

    Yes on the 1"
  6. D

    New Clutch

    I recently installed a new clutch on my IH 674, it works very well when tractor is cold, once it warms and been in use for a while it then will gradually quit releasing getting so bad that I sometimes have to shut engine off to get it out of gear. Any help appreciated, David
  7. D

    Lube pump

    Thanks Pete, tried tapping on pump with hammer and it didn't move. The screw I removed had allen head and was pointed on other/upper end, will try looking in hole again.
  8. D

    Lube pump

    I have Int. 784, I am trying to replace lube pump in lower compartment, I'm at the point where I need to remove two screws that secure pump, manual says remove two screws in bottom of rear frame which secures pump, I found one hole and I did remove one screw, is there another screw in same hole...
  9. D

    784 water problem

    Thanks, pull the pan not good, but, man has to do what a man has to do. Again thanks to everyone greatly appreciated.
  10. D

    784 water problem

    Thanks, very good input.
  11. D

    784 water problem

    Thanks for the reply, lots of things to consider.
  12. D

    784 water problem

    Thanks for the reply Bob, gives me a place to start.
  13. D

    784 water problem

    I have a 784 Diesel that is belching up water, (out of radiator with ten pound cap) temp. gauge scale lets say 9 to 3 on clock, needle reads 10-11, gauge works fine. this is with 8 ft. disk running in L-4 at 1500 rpm If anyone can help me with this I would greatly appreciate it. Thanks in...
  14. D

    784 PTO output shaft cover

    Thank you for your reply, I have that information written down for future use if needed.
  15. D

    784 PTO output shaft cover

    And Phil from what I remember it was fine threads.
  16. D

    784 PTO output shaft cover

    All I will be able to give you is a close measurement on the ID of the threads on the bearing retainer flange, and that will be in the morning.
  17. D

    784 PTO output shaft cover

    Yes it sure is.
  18. D

    784 PTO output shaft cover

    Happy New Year to everyone. I'm in need of a PTO output shaft "cover" if anyone can help me with this I would really appreciate it. I've looked every where I could think of and haven't found what I need. David G.
  19. D

    784 PTO output shaft cover

    Happy New Year to everyone. I'm in need of a PTO output shaft "cover" if anyone can help me with this I would really appreciate it. I've looked every where I could think of and haven't found what I need. David G.
  20. D

    784 Park Brake

    I'm moving forward with my project, will lift the cover off today. Thanks for the help, David
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top