(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. H

    2090 power shift troubles

    What kinda pressure ...175-210 in each pack?
  2. H

    2090 power shift troubles

    Is the control valve(valve body) the same as the one under the floor on the 1070? If so I have one.
  3. H

    2090 power shift troubles

    Why does my 2090 lock up the transmission when I shift to reverse on my powershift 2090?
  4. H

    TR 70 motor problem

    Hi..went to start the 390 gas motor today and it started right off then quit .upon investigation I see smoke rising when the key is on from a resistor block before the coil . So power goes to the resistor block ... through it and out to the coil. That restore got so hot it was smoking. On all...
  5. H

    TR 70

    Thanks
  6. H

    TR 70

    Anyone know what the settings are for a TR70 NH combine to do peas. My book has everything ...except peas
  7. H

    Case 1070 trans/HYDRAULIC Oil

    Ok...who makes it as in what company sells it. Never heard of it.
  8. H

    Case 1070 trans/HYDRAULIC Oil

    I changing the transmission hydraulic differential oil in my 1070 cases. What oil should I put in that system... One tractor is standard...one is powershift.
  9. H

    1070 flow control valve

    I have a low pressure reading on my flow control valve on my 1070. Is this pressure from what the output of the hydraulic pump is???? Meanig I might have to replace the hydraulic pump.? Ihave put in shims which brought the pressure up to near the yellow but it's still not really good. This is...
  10. H

    Case 970 standard transmission low oil pressure

    Thanks...I'll hook that up tomorrow..
  11. H

    Case 970 standard transmission low oil pressure

    Well I took the flow control apart...it's been apart before as witnessed by the 2 blue...lol..shims. But the shims measure 5/16 thick in a stack. My one that was burned is way less than that....would this tend to mean the PTO clutch needs rebuilding or do I just add more shims to the regulator...
  12. H

    Case 970 standard transmission low oil pressure

    Thanks very much...
  13. H

    Case 970 standard transmission low oil pressure

    Morning...Well my project 970 is running...oil pressure is perfect in motor but the oil pressure in the transmission is reading low... This is a standard transmission model...what pressures the transmission?? Never heard of a standard transmission being pressured before....I can understand the...
  14. H

    970 tires...

    Thanks
  15. H

    970 tires...

    Does anyone know about installing 18.4 X 34 tires on rims that had 20.8 X 34 tires on them...will it work...found some really good shape 18.4...20.8s are rare as hen's teeth up north where I live. New are rediculously priced.
  16. H

    970 case rear axle seal.

    Hi... finally got the hub off the 970 rear axle... Anyone know what number that rear seal would be. Not a number anywhere on mine...or at least one I could find. Appears to be 5 and 1/4 of...I'd is tough to say as seal is so damaged. Any ideas or numbers to check... And the serial number...
  17. H

    1070 rear hub removal

    I've not had one apart before...what actually happens...does the out part push back with the three puller bolts or does the part the bolts are threaded into pull forward on the axle...?
  18. H

    1070 rear hub removal

    Yeah... figured that might help...did you take off the out hub??? The part the wheel wedges connect to... probably easier to swing a sledge...?
  19. H

    1070 rear hub removal

    Any suggestions on how to free up the inner hub on the rear axle would be appreciated. I'm trying to remove the rear hubs to replace the rear axle seals. This tractor sat for years in a dairy barn before I got it so rust has been an issue on all rebuilding. I have removed the center hub bolts...
  20. H

    970 married to 1070

    I could ...but I purchased a 15 inch clutch and pressure plate by mistake and have them and no original clutch and pressure plate ..both totaled ...from the the 970 I bought. With the 1070 engine I'm not going to be able to fully utilize that motor as it will probably smoke the clutch a...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top