Search results

  1. L

    Jubilee won't start

    Thanks!
  2. L

    Jubilee won't start

    it has one small terminal and two large terminals.
  3. L

    Jubilee won't start

    I will try the "wiggly" function and the work around for the ground wire.
  4. L

    Jubilee won't start

    not sure. it is a chinese version from amazon.
  5. L

    Jubilee won't start

    My 1953 Ford jubilee won't start unless I apply 12 volt power to the battery terminal on the starter. Then it will start and run. I've checked connections, I've replaceed the solenoid and coil. The tractor has electronic ignition so no points or condenser. When I push the starter button on...
  6. L

    Two problems...

    Thanks to all. I used a wheel puller. It was still stubborn but it popped off.
  7. L

    Two problems...

    I'll try my new wheel pullers tomorrow. Went to my grandaughter's softball game tonight.
  8. L

    Two problems...

    I have purchased a new one.
  9. L

    Two problems...

    Thanks for the information.
  10. L

    Two problems...

    I'm gonna have to remove the existing ones to see. Thanks.
  11. L

    Two problems...

    OK. Will do. Thanks.
  12. L

    Two problems...

    I've used WD40, but I will try the CRC. Thanks.
  13. L

    Two problems...

    I'm having a difficult time finding part numbers for the 2 tie link boots on each side of a 1950 Ford 8N. Also what is the best way to remove a stubborn steering wheel on the same tractor? I've tried heat and a big ball pin hammer. Thanks in advance for your help!
  14. L

    8N Charging Issue

    Thanks for the input. I plan to check it tomorow morning.
  15. L

    8N Charging Issue

    I'm sorry but I misspoke. It is amps not volts.
  16. L

    8N Charging Issue

    I checked the ammeter and it was bad. I replaced it and everything seems to work just fine now except when the tractor is running at about 1/2 throttle, the ammeter shows it charging at about 20-25 volts. When I shut the tractor off, the ammeter hand goes back to the middle as it should. Any...
  17. L

    8N Charging Issue

    According to all I've read, you are correct in the polarizing terminals. I'm thinking when I polarized from battery to field that I popped the ammeter. The ammeter reads either pegged out on the positive side or pegged out on the negative side (when the tractor is not running). The meter hand...
  18. L

    8N Charging Issue

    I have a 1950 Ford 8N 6 volt positive ground I'm trying to fix up and I have a charging issue. The issue is that the ammeter read all the way to the - negative side of the ammeter so i checked to see if the generator was charging and it is, up to about 7.4-7.8 volts+ from 6.4+ volts. I put a...
  19. L

    Headlights will not work

    Concerning my 1983 John Deere 750 compact tractor, my hazard, work, and tail lights all work perfectly but my headlights will not work. The sockets each have two contacts and I have power to one of the contacts in each socket but no power to the other contact in each socket. Any ideas as to...
  20. L

    lift arms don't lift all the way up.

    The control lever was and is in the "up" position as you had suggested. One thing I noticed last night was the bush hog raised to a higher height than ever before when I raised the lift lever. The tractor had been sitting for 5 days since last use.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top