(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. M

    To35 universal tractor fluid

    I have a 1955 TO-35. What transmission/hydraulic fluid is recommended? Can it use M2C-134D Ford spec oil? It is cold northern climate here and my hydraulics are very sluggish in teens temps I have now.
  2. M

    Fishing1

    I have a 1955 TO-35. What transmission hydraulic fluid is recommended? Can it use M2C-134D Ford spec oil?
  3. M

    Help identify my 9n

    I see no evidence of any effort made to clean the stamped serial number plate on left side of motor. Everything you need is right there on that plate. You need to take a power grinder with wire wheel to it. Removes all old paint, rust, oil. Be aggressive and persistent till it gets shiny.
  4. M

    1942 value

    As it has been shown no care in many years and is non running. Only worth $500 in most areas. Could be a money pit to get repaired. Has a "Superior" brand loader.
  5. M

    Ford 600 steering

    ore than likely steering box needs to removed, disassembled and new bearings and seals installed. Yesterdaystractor sells parts to rebuild. If you don't feel up to rebuilding you can buy a new steering box, or hire someone to repair it. Youtube has videos on steering box rebuild for n series...
  6. M

    Ford Maintainer Blade

    found it on tractor data
  7. M

    Ford Maintainer Blade

    wish I could of found the picture. Searched for 20 minutes with no luck...Need more search info
  8. M

    New owner need help

    Buy a quality service manual right from this site. Look up a wiring diagram: http://fergusontractors.org/nfs/wp-content/uploads/electrical/TO-30-6V.pdf http://fergusontractors.org/nfs/wp-content/uploads/electrical/TO-20-6V-ammeter.pdf These two diagrams are for 6volt since you didn't specify...
  9. M

    Photo Whats it worth

    they are about $50 each at yesterdays tractors for aftermarket. At least 50- 75 dollars each for originals is not unheard of. .
  10. M

    Early TO35 hydraulic pump

    The pump for sale on this site says for a TO-35, the serial number must be 179304 or higher.
  11. M

    Early TO35 hydraulic pump

    You need to know your tractors serial number and make sure it matches the pump. I have a 1955 and its serial number doesn't match their pump.
  12. M

    TO-35 throttle/governor linkage adjustment

    I got it fixed. Thank you all for your good advise.
  13. M

    TO-35 throttle/governor linkage adjustment

    I don't know what a turf 35 is. Mine is just a regular farm tractor with gas Continental Z134 motor.
  14. M

    Eastern Wa.?

    I live about 4 miles out of Medical lake as bird flies.
  15. M

    TO-35 throttle/governor linkage adjustment

    I just bought a 1955 TO35 and the linkage is not right. The tractor when started goes right to 2200 rpm and moving throttle lever to idle position doesn't slow it. Does anyone have concise instructions on adjustment? I have an I&T manual I am having trouble understanding as it has little...
  16. M

    Z134 To-35 engine rebuild

    First, check carburetion and timing. You will need sleeve puller, expensive so borrow one. Need good torque wrench. Send head to good head shop to go over. It isn't a one day job.
  17. M

    860 carb fills air inlet hose w/fuel.

    I took carb apart today, and it turned out that float was dragging on side of bowl. Had to squeeze two floats closer together by just like .030". Now it doesn't stick or flood gas into the air inlet. It starts so much better. I am happy.
  18. M

    860 carb fills air inlet hose w/fuel.

    I have a 1955 ford 860 with MS carb with #593 and 3/1955 stamped on it's brass plate. It is filling up chamber above float and putting a cup or two of gas into the rubber hose air inlet, then it is flooded and won't start cold. I always turn fuel off when not in use. Fuel shutoff at tank is new...
  19. M

    timing marks for TO35 flywheel

    I put white paint on the six degree mark. Is this correct for my Z134 gas motor?
  20. M

    Removing front timing cover under water pump and oil pan

    I have the IT SERVICE MANUAL from Yesterday's tractor.
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top