(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. G

    JD 60 Clutch

    Dylan at Wengers in Pennsylvania found a clutch collar for my JD60.
  2. G

    JD 60 Clutch

    Thanks again for everyone's input. I've contacted all states and they're out of stock but are checking their salvage yard. I'm following up on every ones suggestions. Thanks!
  3. G

    JD 60 Clutch

    The attached photo is the clutch collar (part #A 4360R) out of a 60. Can't find it in john deeres parts catalogue. Any ideas where I can get this part or do I need an expert metal repair person, Thanks
  4. G

    John Deere 60 clutch

    Thanks to everyone who responded. You guys are great!
  5. G

    John Deere 60 clutch

    Thanks for your response. You're right. Changing out the disc at this point would save a whole lot of cussin during a complete tear down!!
  6. G

    John Deere 60 clutch

    I've adjusted the clutch on my 1956 JD60 many times and I still get a jumpy movement when I engage it. It has a nice snap to it either engaging or disengaging and I've been very careful to adjust the bolts equally. I have pulled the disc and they appear to be flat and I've blown out the dust...
  7. G

    MF 245 orchard tractor

    If there is nothing on the hitch it's pretty slow. with my 800 lb mower it's a matter of minutes. Thanks for responding.
  8. G

    MF 245 orchard tractor

    When the tractor is shut off the three point hitch slowly lowers itself. Is there something simple, like and o ring, that can solve this problem. I do have a shop manual but I can't find anything in it that addresses that problem. Other than that issue the hydraulics work great and the three...
  9. G

    MF245

    I have a 1978 MF245 diesel orchard tractor purchased from my late uncle a few years ago. It has 2000+ hours and everything is pretty much original. The battery tests static at 13.4 volts and when running about 14.3 volts. The starter clicks and after about 4 or 5 turns of the key she'll fire...
  10. G

    farmall 300

    I don't have a serial number. The loader on it was an older farmhand with a manual dump which I added a hydraulic cylinder. I sold the tractor to a private person who after a year traded it in for a kubota. (Ginops is the kubota dealer here in Willimsburg Mich.) They sold it to someone in...
  11. G

    farmall 300

    I'm looking for a farmall 300 that was purchased at Ginops in Williamsburg Mi. It had a loader and 2. hitch. There is also a homemade hydraulic additional resevoir. The rear tires were new at the time. This was my very first tractor and maybe whoever owns it now might want to sell it to me...
  12. G

    JD60 no oil pressure

    Thanks for your comments. It was a broken coupling which I was able to find both pieces. Got a new one coming from Yesterdays tractors. Just for my own knowledge are there other old JD parts suppliers that I could also use to find parts?
  13. G

    JD60 no oil pressure

    I Started my JD60 during a cold spell last month and had no oil pressure. Discovered ice in the crank case. I cleaned it out, changed the filter and added new oil. Now,I do not have any pressure in the line going to the gas shut off or the pressure gauge. How can I check if the pump is bad...
  14. G

    JD 60 oil filter

    jm. Thank you
  15. G

    JD 60 oil filter

    I've been waiting 5 weeks to get an oil filter for JD60 from my local JD dealer. They claim it's a supply chain issue. Does anyone know if other filter makers would have one and what would the brand and number be. Thank you fellow JD fans
  16. G

    JD60 charging system

    Thanks for the advice. The battery ground was bassackward...problem solved and she's putting out 13.5 to 14 volts at fast throttle. I didn't re-polarize it since it's putting out a good charge. Thanks again guys
  17. G

    JD60 charging system

    The battery voltage is 12.6 engine off. Tractor running high rpms battery voltage is 13.7. I installed a new voltage reg because occasionally the battery would not crank the engine enough to start it. However the ammeter reads on the + side when I turn the lights on, engine not running and...
  18. G

    Farmall 300

    I'm looking for a farmall 300 with fast hitch and older loader that was sold by Ginops in Williamsburg Michigan about 20 years ago. The latest information I have is it was sold to some one in Mancelona Mi. This was my first tractor and I'd like to buy it back if I could be so lucky. If you...
  19. G

    Adjusting vavles on JD60

    Thanks Mike M for the advice. Valves adjusted and tractor starts and runs very well. I'm in northern Michigan and will not be driving the tractor and will only start it a couple of times before Spring. Since the head bolts need re-torquing when the tractor is "hot" is there a problem with...
  20. G

    Adjusting vavles on JD60

    I just installed a new head gasket and new intake and exhaust manifolds on my 1956 JD 60. Since I'm not a mechanic, but can follow directions (not according to my wife!) the service and parts manual helped immensely. The manual is not clear to me on adjusting the tappets. Any advice would be...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top