-
D
dragging brakes
I did the axle seals and brakes on my 48 8n this summer. The right brake is dragging enough that it will pull noticeably to the right but only at one spot on each revolution. I have very little brake going forward but will lock up in reverse. I put new springs on. Any ideas would be...- daleiniowa
- Thread
- Replies: 2
- Forum: Ford 9N, 2N & 8N
-
D
finish mower help
Thanks to all for taking the time to reply.You have reinforced what Ive always thought. My challenge is when my neighbor expanded our shared pond, I let him spread the the bottom of the pond, good old black dirt, on my ground and I seeded it. The result is parts of the grass grows 2x as fast...- daleiniowa
- Post #7
- Forum: Ford 9N, 2N & 8N
-
D
finish mower help
I currently mow 6 acres each week with a 60 inch Priefert finish mower with rear discharge and my 8n. Up until 5 years ago I used an old Ford bush hog but with newer homes going up in the area, I needed to make it look better. My challenge is no matter what I do, it leaves windrows and I have to...- daleiniowa
- Thread
- Replies: 16
- Forum: Ford 9N, 2N & 8N
-
D
installing rear hubs
I have had my 48 8n for 40 years. I discovered this forum many years ago and have learned a lot. Ive replaced the rear axle seals by using mostly John Smiths article. One hub was worn so I went ahead and replaced both. I cant get them on all the way even with a hammer and block of wood. They...- daleiniowa
- Thread
- Replies: 3
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy