(800) 853-2651
SHOP NOW

Search results

  1. T

    John Deere 140 Engine Issue

    Thanks guys for all of the comments and suggestions. I will check them out one at a time and see what helps.
  2. T

    John Deere 140 Engine Issue

    My 1968 JD 140, SN3457, 12hp Kohler, starts and runs fine for about 20-30 minutes of mowing and then sputters/sometimes backfires and then dies unless I back off the throttle. It will continue to run and mow at about half throttle, but will sputter and die if throttle is increased. It has new...
  3. T

    Front Pedestal Restoration

    Probably.
  4. T

    Front Pedestal Restoration

    Tripp, Are you sure that is not the original factory grinding after the pedestal was removed from the mold? If original, I would not touch it.
  5. T

    50 W question

    In 1953, high clearance Model "50" tractor serial numbers were recorded as they came off the line as "50-W" (wide front) and "50-N" (16" single front). Beginning in 1954, the "W" and "N" designations were discontinued. High clearance tractors continued to be built, but there is no serial number...
  6. T

    JD BN/BNH ?

    As stated previously, there was no BNH designation beginning with the Late-Styled Model "B". If the rear axle casting is B2406R, the tractor is considered a "BN" (a B2405R casting would be found on the regular row crop Model "B").
  7. T

    JD 2-Cyl. Mechanic in Webster, WI?

    Thanks! I will contact Jerry.
  8. T

    JD 2-Cyl. Mechanic in Webster, WI?

    I have some plugged idle jets and a clutch that probably needs rebuilding on my Late Model "A".
  9. T

    JD 2-Cyl. Mechanic in Webster, WI?

    Can anyone recommend an experienced JD 2-Cyl. mechanic in or near Webster, WI?
  10. T

    Solid rear wheels

    Those are 12x28 pressed steel wheels and the part # is JD3007T. They are still available new from Deere for $700+ each. They are difficult to find used in decent condition because of Calcium Chloride leaks from loaded tubes.
  11. T

    JD MIO from a Florida Orchard..photo's

    Nice!
  12. T

    JD 800 Hitch

    When adjusting the lift arms on a JD 800 hitch (not an 800A or 801), what is the maximum amount they can be lowered? How many inches of threads need to be left in the housing?
  13. T

    Weight of JD No.44 plow?

    Thanks Bob! That is important information that my owner's manual is missing.
  14. T

    Weight of JD No.44 plow?

    Does anyone know the weight of a JD No.44 plow with 14"/16" frame on rubber with a steel rear wheel?
  15. T

    BarberGreen50

    No, I'm sorry you did say they "sold". Here is your post to refresh your memory. Don't we know you by some other handles as well? What business is it of yours what price someone puts on their property. Let it go, I turned down your offer, move on. Re: BarberGreen50 in reply to deerman...
  16. T

    BarberGreen50

    Hey tractorbafoon, If there is someone out there that will sell you a one-of-94-built tractor for $3K or less, they are a bigger "bafoon" than you. Oh, and I just looked at those AZ units a couple of months ago (in AZ) and they are still owned by the same gentleman that has owned them for years...
  17. T

    BarberGreen50

    Here you go again farmerboy. I thought you had crawled back under your rock. You have no idea what it means to be truthful. Yes, I have a complete and original Model "50" Barber-Greene tractor. Yes, I have many parts from a parted-out unit. However, I have NEVER, let me repeat that, NEVER...
  18. T

    Any JD parts houses in the Appleton, WI area?

    Hi Curtis, Just in the area for the weekend and checking to see if there was any 2-cyl entertainment. I do need some 9-bolt hubs for a late-"A" and seat frame for same, and always looking to see what is available.
  19. T

    Any JD parts houses in the Appleton, WI area?

    Anyone know of any good JD parts houses near Appleton, WI?
  20. T

    Dean Sabinske

    Yes, Dean is the best! You will not be disappointed.
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top