#1 spark plug wire

Dr. Bert

Member
Replaced the block in my 60 and now hooking up all the ignition etc. If memory serves me correctly, I think I have read that the #1 spark plug wire go in the top contact on the distributor cap. Is this correct? Thanks.
 
IF it’s put together right it will be the top hole goes to the flywheel or left or #1 side. Best way to make sure is to take the #1 plug out and hook the plug wire to it and turn the engine with the switch on until it crosses 5* on the flywheel and watch to see if it sparks. This should make sure everything is together correctly and set timing on the engine at the same time.
 
CORRECT, the original configuration was that way, but if the mag or distributor happens to be installed 180 out of time, the wires would need reversed in order to run mind you...

John T
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top