10006 Deutz

teddy52food

Well-known Member
Checked compression yesterday. 300 psi or better on all. Can't even get any smoke out of it. Bled the lines by the injectors & have a good squirt of fuel there. I have the line in the pump on the pointer & #1 on tdc on the comp. stroke. # 6 is on the rock. What am I missing? #1 is by the flywheel. Lines are on the bosch rotary pump 153624. Shop is 60-65 degrees.
 
I know Deutz has number one at flywheel, but on Bosch inline pumps number one is always at the DRIVE end of pump. I'm wondering if pump is 1/2 turn off in relation to crankshaft. You MUST have fuel entering on compression stroke, NOT on exhaust/intake overlap. I don't recall which outlet on the Bosch VA pump you have is the FRONT injector line that I think the inside timing pointer aligns with. I don't recall that mark being used on the flywheel end cylinder..
 
It is a rotary pump. The key slot lines up with the port on #1. That is when the pointer is on the line too. If I loosen the #1 line with the cover off & watch the valves it squirts after intake & before ex. I don't think I am 180 off. 180 off it would squirt between ex & in. I have tried a little retard & a little advance from where it is & still nothing.????????????
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top