10006 Deutz

Smoke on trying to start is bluish dark gray not white like unburned fuel. It doesn't start even in this warm weather without a sniff of ether. It doesn't take much. There is a slotted connection on the pump gear drive. I tried both advance & retard but it made no difference. It was in the center to begin with. Once it is running , it sounds good with a little diesel rap when you open it up.
 
Hadn't run since 2009. Was stuck. One had rust in it & I got it apart & honed the rust out & put new rings on that piston. Compression checks the same on all 6. I took the pump off before trying to get it loose as I didn't want to damage it if it was stuck. I can't time it on the marks so have to guess. Runs with the marks on the pulley about 2 1/2 inches from the pointer. I had the pump rebuilt & rebuilt injectors too. I am wondering if I may be a cog late?
 
Well if you cant get to the timing marks on the gears, can you perhaps time it using the marks on the balancer? Never saw one of those pumps before, does it have a timing pin or marks to line up on it somewhere? The way youre describing it, it does sound like a tooth retarded. Advancing it all the way may not be the full tooth that you need.
 
Mark on the front pulley lines up with the pointer when # 1 or 6 are on the rock. TDC. There is a mark in the pump that is close to the pointer. When it comes to the pointer it goes back by itself about 1/8 on an inch. Retarded. The mark on the pulley is coming up to the pointer but over 2 inches to go yet when the pump marks are close. That is where it is now to get it to run. But I think it should start without ether in this warm weather.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top