oes not matter(quoted from post at 10:12:49 09/24/22) 3# wire alternator. Where should I locate the 12 to 6 volt resistor? In front of the original resistor that is mounted on the dash or after it?
TY
SDE
ot all the same. Ford with front mount coil uses ballast resistor and 6v battery voltage. Such coil has very low resistance of around 0.5 to maybe 1.5 Ohms(as aftermarket coils entered picture) and the 6v divides about 50/50 between the coil & resistor. Many others have a coil with about 1.2 to 1.3 Ohms use no ballast resistor, such as 8N side mount distributor, Farmall SMTA, NAA, etc.(quoted from post at 14:47:08 09/24/22) I never worked on a 6v tractor?
Did 6v tractors use a ballast resistor?
If so what voltage showed up on the coil, what voltage across
the Ballast and what current does the coil need?
Someone converted my Jubilee before I bought it.
The ballast uses 6v, coil 6v and 4 amps current in the coil.
That works and doesn't burn the points..
0 Ohms in alt excite circuit is the value GM used. It was in parallel with the charge indicator lamp. Whereas a ballast resistor is typically closer to 1 Ohm & as you say is not suitable for the alt excite circuit.(quoted from post at 17:02:46 09/24/22) Okay thanks JMOR! I partly misinterpreted what the OP
said in addition I did not know that there were 6 volt
systems that reduced coil current by using a resistor.
To the original poster hopefully you know that your ..12
to 6 volt resistor.. has nothing to do with the alternator
wiring. Resistors can be used in place of the diode
shown in the attached diagram At the moment I cannot
give you a certain value for a resistor that would work, I
believe a 10 ohm would do it. Maybe someone
else can chime in to agree or give the correct value. A resistor commonly used to
reduce coil current will not work properly when placed
in the excite circuit to spade terminal 1, the engine will
continue to run when the switch is turned off.
Delco 10si wiring diagram
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy