1365 Injection pump not pumping.

Did you loosen both bleeder screws Does fuel squirt out of the one with pressure? Have you checked to see if you have water/ice in either filter?
 
After you get diesel squirting out the bleeder screw it takes a while to prime the lines to the point your really over taxing the starter.I crack the lines at the injectors then pull it in 5th gear to prime the lines then tighten them and pull start it
 
It is of the tractor now. But we had fuel through the entire thing but it will go though the return line back to the tank and there is nothing out the injector holes. I tried to mess with plugger and it seems fine.
 
Well... the likeness of since 2010 because the tractor run for a while and die, let sit for 10 min it would right back up. I rebuilt the pump and put back on Nov 2015 bleed the pump and no fuel out the lines. So I took it of and bench tested it. Nothin
 
I had fits with mine last summer...put new lift pump on it...ended up being a little piece of rubber stuck in the fuel line that goes from tank to lift pump...right next to lift pump where it converts from rubber hose to the little metal fitting that bolts to the lift pump...there was a piece of rubber in that little metal fitting.
Reaver
 
Sounds like the lift pump is weak,had almost exactly the some thing happen on my
2WD 1365 and a new lift pump cured it.You can get a brand new one from New Holland these days.Appears to be a better pump than the aftermarket ones.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top